AEG IKE95771FB User Manual page 16

16 www.aeg.com
• The heat setting display of the left
front control bar shows the heat
setting for this function. To change
the heat setting use the left front
control bar only. The left rear control
bar is deactivated while the function
operates.
Use only one pot with a
minimum bottom diameter of
160 mm when you operate
the function.
1. Place the correct cookware on the
left front side of the cooking area.
2. Press and hold
hob.
A signal sounds and indicators above
and appear.
3. Press
A signal sounds and an indicator above
the symbol appears.
4. Move the cookware back and forth
on the cooking area as needed.
The heat setting level on the control bar
adjusts automatically.
5. To change the default heat setting
levels, move the cookware to the
area you want to adjust first.
6. Press any of the available heat
setting levels on the left front control
bar.
The updated heat setting levels will be
remembered for the next time you use
the function.
7. Repeat the procedure for the
remaining cooking areas, if needed.
8. To deactivate the function, press
You can also press 0 on the left front
control bar.
A signal sounds and the indicator above
the symbol disappears. The heat setting
level changes to 0.
to activate the
to activate the function.
You can set a timer while PowerSlide
operates. In this case the timer does not
deactivate the cooking zones when the
set time runs out. The timer affects all
three cooking areas activated by the
function at the same time.
6.7 Hob²Hood
It is an advanced automatic function
which connects the hob to a special
hood. Both the hob and the hood have
an infrared signal communicator. Speed
of the fan is defined automatically on
basis of mode setting and temperature of
the hottest cookware on the hob. You
can also operate the fan from the hob
manually.
For most of the hoods the
remote system is originally
deactivated. Activate it
before you use the function.
For more information refer to
hood user manual.
Operating the function automatically
To operate the function automatically set
the automatic mode to H1 – H6. The hob
is originally set to H5. The hood reacts
whenever you operate the hob. The hob
recognizes temperature of the cookware
automatically and adjusts the speed of
the fan.
Automatic modes
Auto‐
matic
light
Mode H0 Off
Mode H1 On
Mode On
3)
H2
Mode H3 On
.
Mode H4 On
Mode H5 On
Boil‐
2)
Frying
1)
ing
Off Off
Off Off
Fan Fan
speed 1 speed 1
Off Fan
speed 1
Fan Fan
speed 1 speed 1
Fan Fan
speed 1 speed 2