Troubleshooting - Bush SR190DG Instruction Manual

Product support
Help is always at hand

Troubleshooting

No power:
• Check the power plug connection at the back of the Soundbar and at the wall socket.
• Check that you are not in Standby mode. Press and release the Power button on the
Soundbar or on the remote control.
Unable to pair with a Bluetooth device:
• Check that you are in Bluetooth mode.
• Ensure that you are within range of the Soundbar for Bluetooth functionality, 10
metres or less (33 feet or less).
• Check that the device you are attempting to pair with supports A2DP stereo audio
transmission.
• Move any other unnecessary Bluetooth devices/electrical equipment away from the
Soundbar and if possible, turn them off or disable their Bluetooth functionality.
No sound / sound distortion:
• Adjust the volume
• Increase the volume on the secondary device and on your Soundbar.
• Check that you are in the correct mode for the music that you wish to listen to.
Remote control does not work:
• Reduce the distance between the remote control and the Soundbar.
• The remote control batteries may be exhausted. Replace the remote control batteries.
• The remote control needs clear line of sight, without obstacles, to function correctly.
Direct sunlight or other bright light sources shining on the remote sensor may affect
the performance.
Soundbar powers off:
• Your Soundbar has been designed to automatically go to Standby mode after
approximately 15 minutes without an audio signal, to save power. Press the Power
button on the Soundbar or on the Remote control to turn your Soundbar back on
again.
34
Product support