Hitachi HC-A16KNX Installation And Operation Manual page 13

Installation
n DIP switch setting
Name Function
SW1-KNX PCB Reset KNX PCB
SW1-H-LINK Not avaliable
PCB
SW2 Reset
SW3 Not available
(TELE)
SW4 Configuration
SW5 Configuration
SW6 Configuration
SW7 Options 2
SW8 Options 1
(Application type)
SW9 Not available
SW10 HC-A16KNX
address
SW11 H-LINK DSW
D4, D11 H-LINK
D5 Not used
D6 Units configuration
alarm
D7 Power
D9/D10 Not used
D12 KNX
D13 Operation
Factory setting
Reset button. To be used in case of KNX communication has been locked.
All in off (no function)
Reset button. To be used in case of program has been locked
Factory purposes. Never change it
Setting functions
Setting functions
Setting functions
Configuration as MASTER HC-A16KNX: SW7-1=ON.
Only one HC-A16KNX can be set as a MASTER HC-A16KNX. Setting by default.
Configuration as SLAVE HC-A16KNX: SW7-1= OFF.
It should be 1 HC-A16KNX configured as MASTER, all the rest of HC-
A16KNX must be configured as SLAVE
All in off (no function)
All in off (no function)
HC-A16KNX address from 0 to 31 by pins 1 to 5
SW11-1: H-LINK end resistance
SW11-2: Not used
H-LINK transmission
ON- No alarms
OFF- Units not configured
Power supply ON/OFF
-
Internal communication between the KNX PCB and the H-LINK PCB.
Normal software operation
Description
PMML0193A rev.2 - 06/2010
11