Table of Contents
Advertisement
3
WORK
3.1
Adjusting the handlebar height/position
Info
The handlebar stub position must be identical on the left and right of the vehicle.
Adjusting the high position of the handlebar stubs:
–
Loosen screw
–
Remove screw
100756-11
–
Remove distance sleeve
–
All cables routed under the upper triple clamp must now be routed under the
handlebar stub.
–
Push the handlebar stub carefully up to the upper triple clamp. Watch out for
the handlebar position difference.
Guideline
Handlebar position difference
–
Position the distance sleeve above the triple clamp.
100757-10
–
Mount and tighten screw.
Guideline
Remaining frame bolts
–
Tighten the screw.
Guideline
Screw, handlebar stub
–
Repeat the adjustments on the other handlebar stub.
–
Move the handlebar to and fro over the entire steering range.
»
If the cables restrict the freedom of movement of the steering:
–
100759-01
»
If a component restricts the freedom of movement of the steering or comes
into contact with the trim:
–
Adjusting the low position of the handlebar stubs:
–
Loosen screw
100759-10
–
Remove screw
–
Carefully shift the handlebar stub by the length of the distance sleeve. Watch
out for the handlebar position difference.
Guideline
Length, distance sleeve
Handlebar position difference
–
Lay all cables between the upper triple clamp and the handlebar stub.
–
Position the distance sleeve.
100760-10
.
Info
Loosen the screw several turns to prevent damage to the fork paint when
moving the handlebar stub.
.
.
Correct the cable routing.
Establish freedom of movement and reposition the component.
.
Info
Loosen the screw several turns to prevent damage to the fork paint when
moving the handlebar stub.
with distance sleeve
6.5°
M5
5 Nm (3.7 lbf ft)
M8
20 Nm
(14.8 lbf ft)
.
15 mm (0.59 in)
6.5°
5
Advertisement
Table of Contents
