Table of Contents
Advertisement
FROST PRECAUTIONS
If the appliance is installed in an area where the
temperature can be less than 0 °C, remove the
remaining water from the inlet hose and the drain
pump.
Do this procedure also when you want
to do the emergency drain.
1. Disconnect the mains plug from the mains
socket.
2. Remove the water inlet hose.
3. Remove the drain hose from the rear support
and unhook it from sink or spigot.
4. Put the ends of the drain and inlet hose in a
container. Let the water flow out of the hoses.
TROUBLESHOOTING
WARNING! Refer to Safety chapters.
INTRODUCTION
The start of the appliance does not occur or it
stops during operation.
First try to find a solution to the problem (refer to
the table). If not, contact the Authorised Service
Centre.
With some problems, the acoustic signals operate.
The indicator of button
of the indicators comes on, to show an alarm code:
•
- The appliance does not fill with water
properly.
•
- The appliance does not drain the water.
•
- The appliance door is open or not closed
correctly. Please check the door!
If the appliance is overloaded,
remove some items from the drum
and/or keep pressed the door and
push the
time until the indicator
flashing (see the picture below).
flashes in red and one
button at the same
stops
5. Set any selected programme with option Drain
& Spin and let it operate until the end of the
cycle.
6. When no more water flows, install the inlet
hose and the drain hose again.
7. Press the On/Off button to deactivate the
appliance.
WARNING! Make sure that the
temperature is more than 0°C before
you use the appliance again. The
manufacturer is not responsible for
damages caused by low temperatures.
•
The indicator of button
times and 1 (or 2 or 3) time(s) in yellow: The
mains supply is unstable. Wait until the mains
supply is stable.
WARNING! Deactivate the appliance
before you do the checks.
flashes in red 11
15
Advertisement
Table of Contents
