Backup Proxy Address; Backup Proxy Port; Local Udp Port - Fortinet FortiFone FON-260i User Manual

Backup Proxy Address

When using an outbound proxy, a backup proxy can be defined for use should the primary
proxy fail to respond. The Backup Proxy Address can be an IP address or FQDN.
To assign a Backup Proxy Address:
• Press the
• Select 4. Backup Proxy Address then press the OK button.
• Input the Backup Proxy Address using the dial pad and press the OK button to save your
entry.
• Move to another parameter with the navigation buttons and continue the session or press
the
Changing the Backup Proxy Address requires a reboot of the IP phone. When you exit the
menu, you will receive a reboot notice. Press the OK button to reboot. The IP phone must
reboot to utilize the new values entered.
To enter alphanumeric characters select the
for Dial Pad Mode" on page 61

Backup Proxy Port

The Backup Proxy Port defines the port used when sending SIP messages to the backup proxy
defined in the section
• To assign the Backup Proxy Port:
• Press the
• Select 5. Backup Proxy Port then press the OK button.
• Input the Backup Proxy Port using the dial pad and press the OK button to save your entry.
• Move to another parameter with the navigation buttons and continue the session or press
the
Changing the Backup Proxy Port requires a reboot of the IP phone. When you exit the menu,
you will receive a reboot notice. Press the OK button to reboot. The IP phone must reboot to
utilize the new values entered.

Local UDP Port

The Local UDP Port defines the port, normally 5060, that the phone uses to send and receive
SIP signaling packets. In some instances, particularly when behind a firewall, port 5060 may
already be in use or problematic with SIP aware routers.
To change the Local UDP Port:
• Press the
• Select 6. Local UDP Port then press the OK button.
• Input the Local UDP Port using the dial pad and press the OK button to save your entry.
• Move to another parameter with the navigation buttons and continue the session or press
the
Changing the Local UDP Port requires a reboot of the IP phone. When you exit the menu, you
will receive a reboot notice. Press the OK button to reboot. The IP phone must reboot to utilize
the new values entered.
Configuring your Phone
button, select 2. SIP Configuration then press the OK button.
button to exit the configuration session.
for the character mapping of dial pad digits.
"Backup Proxy Address" on page
button, select 2. SIP Configuration then press the OK button.
button to exit the configuration session.
button, select 2. SIP Configuration then press the OK button.
button to exit the configuration session.
Page 16
button. Refer to "Appendix B. Character Table
16.
FortiFone User Guide for FON-260i