Introduction; Installation; Disconnect Power; Mounting Location - Dometic Go Power GP-TS-50 User Manual

Table of Contents

2. INTRODUCTION

The Go Power!™ Transfer Switch 50 (TS-50) provides automatic power switching

between two separate 120 volt AC input sources, these sources will each contain

two 120 volt 50 amp inputs or a single 120 volt 50 amp input. Sources can include

power cords, generators or onboard inverters. The ATS will sense the presence of

available power supplies and automatically select the proper source.

The TS-50 can be installed at the electrical entry of the RV on the line side of the

main distribution panel, or it can be installed on the load side of the panel between

the main panel and a sub panel, allowing switching for either the entire electrical

load or only designated circuits switch ground bar. A direct access hole to the ground

bar is provided through the enclosure for convenience.

Determine proper connections of wire conductors to electrical terminals. For 120 VAC

wiring, the ground wire is bare or green, the neutral wire is white, and the hot wire

is black.

READ AND FOLLOW ALL SAFETY INSTRUCTIONS!

Make sure the generator is off, the external power cord is unplugged, and the inverter,

if any, is shut off.

The TS-50 mounting location may be on any interior surface where the unit will be out

of direct weather. The chosen location must be accessible after installation is complete

to facilitate future servicing. If possible, mount the TS-50 near the power cord entry or

the location of the generator output. Typical locations include under counter cabinets,

below closet compartments, inside the bed pedestal or cabinets, overhead cabinets,

under-floor storage compartments accessed from the vehicle exterior, etc.

gpelectric.com | [page 3]

Table of Contents