Dometic Seastar DCM User's Manual And Troubleshooting Manual
Dometic Seastar DCM User's Manual And Troubleshooting Manual

Dometic Seastar DCM User's Manual And Troubleshooting Manual

Digital switching

Advertisement

CONTROL
SEASTAR DCM
DCM Digital Switching 026-0003
Product Description
EN
User Manual and Troubleshooting Guide
WARNING
Cancer and Reproductive Harm
[REVISION A] Form No. 0000000.000 mm/19 | ©2019 Dometic Corporation
www.P65Warnings.ca.gov
SeaStar

Advertisement

Table of Contents
loading

Summary of Contents for Dometic Seastar DCM

  • Page 1 CONTROL SEASTAR DCM DCM Digital Switching 026-0003 Product Description User Manual and Troubleshooting Guide WARNING Cancer and Reproductive Harm [REVISION A] Form No. 0000000.000 mm/19 | ©2019 Dometic Corporation www.P65Warnings.ca.gov SeaStar...
  • Page 2: Table Of Contents

    Contents Product Description 1 Explanation of Symbols and Service Center & Dealer Locations Visit: www.dometic.com Safety Instructions Read these instructions carefully. These instructions Thank you for choosing DCM Digital Switching MUST stay with this product. Controller. This User Manual and Troubleshooting Guide...
  • Page 3: General Information

    • If you have any questions regarding any of these Custom modes and frequently used switches can be warnings, contact Dometic. controlled via remote. The system can easily be turned on/ • To reduce risk of severe injury or death. Always wear off with the key fob.
  • Page 4: Layout

    How The System Works How The System Works 3 .3 Layout 3 .5 Key Fob Pairing Procedure In case your key fob lost pairing or you received a new key fob follow this procedure to pair the key fob to the DCM: 1.
  • Page 5: Key Fob Battery Replacement

    How The System Works 3 How The System Works 3 .6 Key Fob Battery Replacement 3 .7 Switching Pages On MFD To access Devices controlled by the DCM on the MFD, navigate In order to replace the key fob battery, use the following to the Switching page, through Home >...
  • Page 6: Top/Bottom Ribbon Setup

    How The System Works How The System Works 3 .8 Top/Bottom Ribbon Setup 4. Select Circuit Control NOTICE: Follow this same procedure for any other page you Edit Overlays want top/bottom ribbon added. Compass Type 1. Go to Switching page and select Menu. Circuit Control Page 1 First Fish...
  • Page 7: Side Bar Setup

    How The System Works 3 How The System Works 3 .9 Side Bar Setup 4. Select Side Bar, then select the data you would like shown NOTICE: Follow this same procedure for any other page you Data want a side bar added to. Side Bar GPS Speed 1.
  • Page 8: Change Switching

    How The System Works How The System Works 3 .10 Change Switching Page Name 3 .11 Replace Switches 1. From Switching menu select Menu 1. Select Edit Switches 2. Select Setup Setup First Fish Port First Fish Port Hole Shot 3.
  • Page 9: Edit Switch Name

    How The System Works 3 How The System Works 4. Quit the menu altogether and enjoy your Switching screen 3. Select Edit Page Setup First Fish Port First Fish Port Hole Shot First Fish Port First Fish Stbd Hole Shot Sweet Spot Night Running >>...
  • Page 10: Warning Manager

    How The System Works 7. Select Edit Name 2. On the next page you will see the list of faults. DCM faults will be labeled SeaStar by Dometic 026-0003: DCM - 0 Edit Switches Edit Name Select a Switch to Edit...
  • Page 11: Update Dcm Configuration File

    How The System Works 3 How The System Works 3 .14 Update DCM Configuration File 5. Select SeaStar Config. File 1. From any screen select Home. Home button will become SeaStar ™ Settings button. SeaStar Instance 2. Select Settings SeaStar Config. File SeaStar Application 3.
  • Page 12 How The System Works How The System Works 9. Select the configuration file you want to update, then select 12. Leave settings Load From Card SeaStar File Transfer NOTICE: The config part number and revision are listed on Sending Configuration Transfer Complete DCM Label (item 13, Section 3.3).
  • Page 13: Troubleshooting Guide

    Check home page of MFD to ensure Switching Icon exist. Update MFD software to 3x pulses (missing MFD) the latest from MFD manufacturer. Check Home/Setting/Communication/Device List for SeaStar DCM. b) Improper DCM setup Device load does not a) Load's associated fuse Remove cover on module.
  • Page 14 MFD during update. It is recommended that a correction to the DCM card reader with SD card the DCM and is powering configuration is made using SeaStar DCM configuration tool so the particular system shuts down off when receiving output does not power off during future configuration uploads.
  • Page 15 Troubleshooting Guide Power Management/ Battery Switches & Key Fob Symptoms Potential Causes Checking Steps and Solutions Load breaker tripped a) Improper voltage a) Measure system voltage and restore by charging battery or blown fuse caused load current if required. to rise causing breaker b) Disconnect load and turn on breaker or replace fuse to see if the breaker trips to trip or fuse or fuse blows, if it does, there is a short circuit within the breaker's associated...
  • Page 16: Nmea 2000 Network Troubleshooting

    Troubleshooting Guide 4 .2 NMEA 2000 • If value is still incorrect: Remove all devices from network, check value again, determine faulty network “T”s , cables or Network Troubleshooting network power isolators by using process of elimination. • Usually troubleshooting requires nothing more than a few Replace necessary items effecting the network backbone.
  • Page 17: New Boat Checklist

    New Boat Checklist New Boat Checklist New Boat Customer Orientation Notes Action Dealer Initial _________________________________________ Power ON/OFF battery switch location and function (off for extended storage) _________________________________________ Turn power ON/OFF using key fob _________________________________________ Explain battery switch ON/OFF cycle, if key fob not available _________________________________________ Explain all key fob functions...
  • Page 18: Warranty Information

    (freight prepaid) within the warranty period to the dealer from whom such product were purchased, or to us at the appropriate address. In such a case Dometic products found to be defective and covered by this warranty, will be replaced at Dometic’s option, and returned to the customer.
  • Page 19 YOUR LOCAL YOUR LOCAL DEALER SUPPORT SALES OFFICE dometic .com/dealer dometic .com/contact dometic .com/sales-offices A complete list of Dometic companies, which comprise the Dometic Group, can be found in the public filings of: DOMETIC GROUP AB Hemvärnsgatan 15 SE-17154 Solna Sweden...
  • Page 20 DOMETIC STUART 7667 SW Ellipse Way, 34997 Stuart, FL United States www.dometic.com © 2019 Dometic MARINE AMERICAS ISO 10592 PRINTED IN USA 12/19 Please scan this QR code form no. 604-0000 REV. B and watch our latest Boating Safety video.

This manual is also suitable for:

026-0003

Table of Contents