Qazqa Tak Fan Black Instruction Manual page 5

7) Installation of the ceiling fan
1. nsert down rod over upper
canopy, then insert the cross
pin over yoke & Cotter pin and fasten the
screws which fix the down rod(Fig 1)
2. Install the mounting plate by screws (Fig.2)
3. Loose the screw from motor.(Fig 3)
4. Install the blade on the motor by
Screws.(Fig.4)
5. Make sure the fan is disconnected from the
electrical supply and carefully insert the fan
into the Mounting bracket. Rotate the fan until
the notch of the hanger ball engages the pin
of the mounting bracket. Then, firmly fix the
screws.(Fig5)
6. Assembly the LED light plate to the light kit
fixing bracket by the screws and connect the
LED light kit by male & female plug. Insert the
remote control receiver on the mounting
bracket. Connect the motor wires, LED light
wires and receiver's power wires to the
receiver by male & female plug.Also,
connect the ground wire by male & female
plug.Then connect the power supply with the
fan.(Fig6)
7. Assembly the shade to the light plate and
assembly the upper canopy to the mounting
bracket. Both rotate
clockwise when assembling.(Fig 7)
If the fan or light kit is PARTIALLY pre-assembled, you can skip the assembly procedures to next step
2
P.5