Operational Safety - Beko INVDMMY User Manual

Instructions for safety and environment
made. Otherwise, there is the risk of electric shock,
fire, problems with the product, or injury!
•
Prior to installation, check if the product has any
defects on it. If the product is damaged, do not
have it installed.
•
Place the product on a clean, flat and solid surface
and balance it with adjustable feet. Otherwise, the
product may tip over and cause injuries.
•
The installation location must be dry and well ven-
tilated. Do not place carpets, rugs or similar covers
under the product. Insufficient ventilation causes
the risk of fire!
•
Do not cover or block the ventilation openings.
Otherwise, power consumption increases and your
product may get damaged.
•
Product must not be connected to supply systems
such as solar power supplies. Otherwise, your
product may get damaged due to sudden voltage
changes!
•
The more refrigerant a refrigerator contains, the
larger the installation location must be. If the ins-
tallation location is too small, flammable refrigerant
and air mixture will accumulate in cases of refrige-
rant leakage in cooling system. The required space
for each 8 gr of refrigerant is 1 m³ minimum. The
amount of refrigerant in your product is indicated
on the Type Label.
•
Product must not be installed in places exposed to
direct sunlight and it must be kept away from heat
sources such as hobs, radiators, etc.
If it is inevitable to install the product close to a heat
source, a suitable insulation plate must be used in
between and the following minimum distances must be
kept to the heat source:
- Minimum 30 cm away from heat sources such as
hobs, ovens, heater units or stoves,
- Minimum 5 cm away from electric ovens.
•
Protection class of your product is Type I. Plug the
product in a grounded socket that conforms the
voltage, current and frequency values stated on
the type label of the product. The socket must be
equipped with a 10 A – 16 A circuit breaker. Our
company shall not be liable for any damages that
will arise when the product is used without groun-
ding and electrical connection in accordance with
the local and national regulations.
•
Product must not be plugged in during installation.
Otherwise, there is the risk of electric shock and
injury!
•
Do not plug the product in sockets that are loo-
se, dislocated, broken, dirty, greasy or bear the
risk of getting in contact with water.
•
Route the power cable and hoses (if any) of the
product in a way that they do not cause risk of
tripping over.
•
Exposing the live parts or power cable to humi-
dity may cause short circuit. Therefore, do not
install the product in places such as garages or
laundry rooms where humidity is high or water
may splash. If the refrigerator gets wet with
water, unplug it and call the authorised service
agent.
•
Never connect your refrigerator to energy sa-
ving devices. Such systems are harmful to your
product.

1.6- Operational safety

•
Never use chemical solvents on the product.
There is the risk of explosion!
•
If the product malfunctions, unplug it and do not
operate until it is repaired by the authorised ser-
vice agent. There is the risk of electric shock!
•
Do not place flame sources (lit candles, cigaret-
tes, etc.) on or close to the product.
•
Do not climb on the product. There is the risk of
falling and getting injured!
•
Do not damage the pipes of the cooling system
with sharp or penetrating objects. The refrigerant
that might come out when the refrigerant pipes,
pipe extensions or surface coatings are punctu-
red causes skin irritations and eye injuries.
•
Unless recommended by the manufacturer, do
not place or use electrical devices inside the
refrigerator/deep freezer.
•
Be careful not to trap your hands or any other
part of your body in the moving parts inside the
refrigerator. Pay attention not to squeeze your
fingers between the door and the refrigerator.
Be careful when opening and closing the door
particularly if there are children around.
•
Never eat ice cream, ice cubes or frozen food
right after removing them from the refrigerator.
There is the risk of frostbite!
•
When your hands are wet, do not touch the inner
walls or metal parts of the freezer or the food
stored therein. There is the risk of frostbite!
•
Do not place tins or bottles that contain carbo-
nated drinks or freezable liquids in the freezer
compartment. Tins and bottles may burst. There
is the risk of injury and material damage!
4 / 25 EN
Refrigerator / User Manual