Table of Contents
Advertisement
Figure 20. Installing the battery cable
Steps
1. Connect the battery cable to the connector on the battery.
2. Align and route the battery cable through the routing guides on the battery.
3. When connecting the battery cable to the battery, you must first lock the connector on the battery by sliding the latch on
the connector.
4. Connect the battery cable to the connector on the system board.
Next steps
1. Install the
base
cover.
2. Follow the procedure in
Heat sink
Removing the heat sink
CAUTION:
The information in this removal section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in
2. Remove the
base
cover.
About this task
CAUTION:
The heat sink may become hot during normal operation. Allow sufficient time for the heat sink to cool
before you touch it.
NOTE:
For maximum cooling of the processor, do not touch the heat transfer areas on the heat sink. The oils in your skin
can reduce the heat transfer capability of the thermal grease.
The following image(s) indicate the location of the heat sink and provides a visual representation of the removal procedure.
After working inside your
Before working inside your
computer.
computer.
Removing and installing Field Replaceable Units (FRUs)
47
Advertisement
Table of Contents
