Advertisement
Procedure
2
3
1
Installing the Finishing-kit
Bracket
Parts needed for this procedure:
1
Foam-marker bracket
1
Carriage bolt
1
U-bolt
3
Flange nuts (3/8 inch)
1
Spacer
1
R-clamp
Procedure
1. Loosen the bolt on the top of the strap (Figure 1).
4
3
2
1
1. R-Clamp
2. Spacer
3. Carriage bolt
2. Place the carriage bolt through the strap of the sprayer
tank belt (Figure 1).
3. Slide the spacer onto the bolt and place the bracket
onto the bolt as shown in Figure 1.
Description
Foam marker (sold separately)
Bolts
Nuts (1/4 inch)
Wiring harness
Switch bracket
Rocker switch
Paddle switch
Bolts
5
Figure 1
4. Strap bolt
5. U-Bolt
Qty.
1
4
4
1
1
1
4
4. Place the R-clamp onto the bolt and secure the bolt
with a flange nut (3/8 inch).
5. Place the U-bolt onto the machine as shown in Figure
1.
6. Place the bracket onto the U-bolt and secure with the
2 flange nuts (3/8 inch).
2
Attaching the Foam Marker
(Sold Separately)
Parts needed for this procedure:
1
Foam marker (sold separately)
4
Bolts
4
Nuts (1/4 inch)
Procedure
Secure the foam marker to the bracket using the 4 bolts and
4 nuts as shown in Figure 2.
g017xxx
2
Use
Attach the foam marker (sold
separately).
Install the switches and route the wire
harness.
Figure 2
g023693
Advertisement
