Hotpoint HPS10L Owner's Manual And Installation Instructions page 9

DOOR ALIGNMENT
Freezer Door
1. Remove the top hinge cover.
2. Loosen the top hinge screws using a hex-head
screwdriver.
3. Adjust the door or put a spacer in between and then
tighten the screws.
4. Reinstall top hinge cover.
Hinge
Cover
REVERSE DOOR SWING
WARNING
Follow all steps when reversing
the door swing. Failure to follow these instructions,
leaving off parts, or overtightening screws, can
lead to the door falling off and result in injury and
property damage.
Left/Right Door Opening Method
This product allows you to reverse the door opening
from left to right and back. You can select your
preference of door opening by following the procedure
to make the change.
Tools Required
Phillips and Flat Head Screwdrivers, Ratchet Wrench
with 8 mm and 10 mm sockets.
Dismantling
1. Affix refrigerator and freezer door by sticking
adhesive tape on both sides to hold doors in place.
2. Remove the upper hinge cover by using flat head
screwdriver. Then remove three screws using
ratchet wrench with 10
mm head. Take out hinge
by pulling it vertically
and keep it in safe place.
Remove the top hinge plug
from the opposite side of
the cabinet top.
49-1000695 Rev. 1
Installation Instructions
Top
Hinge
REVERSE DOOR SWING (Cont.)
3. Remove the adhesive tape on freezer door, lift it
and take off the door and carefully put it aside.
4. Remove two screws of middle hinge using ratchet
wrench with 8 mm socket, and keep them in a safe
place.
5. Remove the adhesive tape on refrigerator door,
lift it and take refrigerator door, and carefully put it
aside.
6. Remove the door stops from the refrigerator and
freezer doors.
7. Insert left side door stops (provided in your packing)
on the left side bottom hole of the refrigerator door
and on the left side bottom hole of the freezer door.
Fasten with screws provided.
9