Table of Contents
Advertisement
Using a Long Range Antenna with a Node
1. Open the Node.
2. Remove the installed mesh antenna by unscrewing it from the connector on the
right side of the Node shelter. You may need to use a 5/16"/8 mm wrench or
small pliers.
3. Screw the external antenna cable into the connector. Do not over-tighten.
ck
bs
External
Antenna
4. Run the cable out the bottom of the Node, making sure it exits against the
foam.
5. Close the Node shelter.
6. Mount the antenna on a pole, as high as possible, using the mounting hardware
included with the antenna.
Note:
If you need a longer cable for installation of the antenna, use an Antenna Extension
Cable, product number 7692.025. See page 20: Adding an Extension Cable to your
Long Range Antenna.
Foam
Cable
Connector
for Internal or
External Antenna
19
Advertisement
Table of Contents
