Table of Contents
Advertisement
StEP 6: (SEE FIGurE 6)
•
Assemble the latch stand plate (3) and the latch
stand bracket (4) at the front of the tray using four hex
bolts (C), washers (J) and hex nuts (E). The aligning
tab on the bottom of the latch stand bracket must be
towards the rear of the cart. tighten.
FIGurE 6
C
J
3
4
E
StEP 7: (SEE FIGurE 7)
•
Place the tray onto the wheel support and position it
so that the latch stand bracket locks into the latch lock
lever. Fasten the tray to the wheel support using eight
truss head bolts (D) and hex nuts (F). tighten.
F
FIGurE 7
6
D
Advertisement
Table of Contents
