How The System Works; Warm Tips; Summary Of Frequently Asked Questions - PetSpy T500 User Manual

6.How the System Works

The Remote Spray Trainer can easily help improve the communication
between you and your dog. At the push of a button the remote sends
a signal to your dog's collar. With three training options - tone, vibration
and spray stimulation - you can ensure you will have a well-trained dog
in a short amount of time.
The trainer can be used for off-leash walks within a range of up to 880
yards. The remote includes and easy- to-read digital display, and the
training collar is light weight, rechargeable and water-resistant.
Using the remote spray dog trainer consistently and correctly,any basic
obedience commands can be taught and many misbehaviors that your
pet exhibits can be corrected.
Important: The remote spray trainer has a range up to 880 yards.
Hold the Remote Transmitter in a horizontal position away from
your body to achieve optimum range.Terrain,weather,vegetation,
transmission from other radio devices,and other factors will
affect the maximum range.

7.Warm Tips

Please read and follow the instructions in this manual.It is important
to wear the collar correctly. When a pet wearing a collar for too long
or too tight can cause skin damage.Too long or too tight wearing may
cause stress, which can lead to skin damage.This is often mistaken
for a burn.
1. Do not tie the device too tightly around the dog's neck.
2. Do not tie your belt to the collar.
3. Do not leave the device on the dog for more than 12 hours.
4. Replace the collar on your pet's neck every 1 or 2 hours.
5. Only used for connection to T500 transmitter and receiver.
-13-

8.Summary of Frequently Asked Questions

Fault Event Boot Failure
Fault State Unable to power on
Press the on/off button(Power) for less than
Reason Analysis
3 seconds
Troubleshooting Press and hold continuously for 3 seconds, or change
Method your finger to press until the device is turned on
Fault Event Boot Failure
Fault State Unable to power on
Reason Analysis Press the power button and the red light flashes
The blue light is on when normal startup. If the red
Troubleshooting
light is on, it means there is no power and it needs
Method
to be charged.
Fault Event Boot Failure
Fault State Unable to power on
Reason Analysis Unable to power off
Press and hold continuously for 3 seconds, or change
Troubleshooting
your finger to press, until the shutdown. Once
Method
shutdown successful,the red light flash, then off.
Unable to spray
Internal solenoid valve doesn't work
(no clicking sound)
1.The product is out of power or the voltage is too low
2.The gas accumulation pressure inside the tank is
too high
Charging
Remove accumulated air (refer to Figure 1)
NO1
NO2
NO3
NO4
Fault Event
Fault State
Reason Analysis
Troubleshooting
Method
-14-