Akai PDP5090 Owner's Instructions Manual page 9

Remove six large screws from the rear side of the display.
4
Insert the bolts, dish-type washers, and insulation holder into the
5
holes as shown in the following figure:
ΠBolt
´ Insulation holder
Hang the protruding plastic part on the rear of the PDP up the groove on the
6
top of the wall attachment panel. Then, lift down the PDP.
(Do not lift down the PDP with too much force. The protruding plastic part
might be taken off.)
16
six screw-
Œ
´
Separating the Display from the Wall Attachment Panel
After lifting the PDP up, pull it forward and remove it from the wall attachment panel.
Œ
´
17