F80CTL and G80CTL: Installation, Start–Up, Operating and Service and Maintenance Instructions
CASING GROUP
Outer door
Blower door
Top filler plate
Bottom filler plate
Bottom enclosure
ELECTRICAL GROUP
Control bracket
Junction box
Limit switch(es)
Circuit board
Door switch
Transformer
Wiring harness 115v
Wiring harness 24v
BLOWER GROUP
Blower housing
Blower cutoff
Blower motor
Blower wheel grommet
TO OBTAIN INFORMATION ON PARTS: Consult your installing dealer or classified section of your local telephone directory under "Heating
Equipment" or "Air Conditioning Contractors and Systems" headings for dealer listing by brand name or contact:
MODEL
HEATING SIZE
(F/G)80CTL
FIRE, EXPLOSION, ELECTRICAL SHOCK AND CARBON MONOXIDE POISONING HAZARD
Failure to follow this warning could result in dangerous operation, personal injury, death or property damage.
Improper installation, adjustment, alteration, service, or maintenance can cause personal injury, property damage, or death. Consult a qualified installer, service agency,
or your local gas supplier for information or assistance. The qualified installer or service agency must use only factory-authorized replacement parts, kits, or accessories
when modifying this product.
Manufacturer reserves the right to change, at any time, specifications and designs without notice and without obligations.
PARTS REPLACEMENT INFORMATION GUIDE
International Comfort Products
Consumer Relations Department
Lewisburg, TN 37091, USA
EXAMPLE OF MODEL NUMBER
WIDTH
045
17
!
GAS CONTROL GROUP
Manifold
Burner assembly
Orifice
Flame sensor
Hot surface igniter
Gas valve
Manual reset limit switches
Burner support assembly
HEAT EXCHANGER GROUP
Heat exchanger cell
Cell panel
Lox NOx baffle (California models only)
INDUCER GROUP
Housing assembly
Pressure switch
Inducer motor
Inducer wheel
Vent elbow assembly
Draft safeguard switch
Power choke (where used)
P.O. Box 128
931-270-4100
COOLING AIRFLOW (CFM)
12
WARNING
49
MINOR SERIES
—