Scholl SH/CK 3000-ML Instructions For Use Manual page 16

Table of Contents

Advertisement

GBA Z 0899 0 E
Cleaning must only be performed by qualified persons who have read and under-
stood these Instructions for Use and are familiar with applicable hygiene rules. En-
sure that care is exercised during cleaning of the unit.
Cleaning of stainless steel
For light cleaning, wipe down the surface with a cloth or soft brush/sponge soaked
in warm water which contains a small amount of dishwashing detergent. Follow this
up by wiping with clear water until no cleaning agent residue remains on the sur-
face, as the latter might cause discoloration or stains. Finish by rubbing the surface
dry.
To remove more stubborn or extensive residue, a stainless steel cleaning product
may be used.
Never use any of the following for cleaning:
 aggressive or bleaching products, i.e., containing active oxygen, chlorine, or
caustic/corrosive constituents.
 abrasive cleaning products such as scouring creams/pastes, steel wool, saponi-
fied steel wool, metal or plastic sponges, or sponges with a scratchy surface
(scouring side).
We recommend you to clean the stainless steel surface once per week using a
standard commercial stainless steel care product. This will result in the formation of
a protective layer which prevents discoloration of the stainless steel surface.
In any event, observe the product manufacturer's instructions and try each product
in a small area first before applying it to a larger surface.
Deposits and stains on the ceran hob must be removed quickly, preferably on the
lukewarm ceran glass. This should be done before re-using the ceran hob.
It is recommended to use a dry cloth for light and thin deposits. The enclosed scrap-
er is instead designated for more stubborn deposits.
If the use of these agents is not sufficient, suitable
used on the cold ceran glass.
To remove the most stubborn incrustations, the ceran glass can be covered for a
whole night with a cloth soaked in water and cleaning agent, after which the clean-
ing work is to be repeated the following morning.
BA
Last revised 04-2019
non-abrasive
Page 16 of 24
products must be
April 17, 2019
Rev. 0

Advertisement

Table of Contents
loading

This manual is also suitable for:

Z 0899

Table of Contents