Advertisement
21. When using iFIT.com programs, an electronic
"chirping" sound will alert you when the
speed and/or incline of the treadmill is about
to change. Always listen for the "chirp" and
be prepared for speed and/or incline changes.
In some instances, the speed and/or incline
may change before the personal trainer de-
scribes the change.
22. When using iFIT.com programs, you can man-
ually override the speed and incline settings
at any time by pressing the speed and incline
buttons. However, when the next "chirp" is
heard, the speed and/or incline will change to
the next settings of the program.
23. Remove iFIT.com CDs and videos from your
CD player or VCR and disconnect your MP3
WARNING:
Before beginning this or any exercise program, consult your physician. This
is especially important for persons over the age of 35 or persons with pre-existing health problems.
Read all instructions before using. ICON assumes no responsibility for personal injury or property
damage sustained by or through the use of this product.
SAVE THESE INSTRUCTIONS
The decals shown at the right have been placed on the
treadmill. If a decal is missing or illegible, please call the
telephone number on the front cover of this manual and
order a free replacement decal. Apply the decal in the loca-
tion shown.
player when you are not using them.
24. Never insert any object into any opening.
DANGER:
25.
Always unplug the power
cord immediately after use, before cleaning the
treadmill, and before performing the mainte-
nance and adjustment procedures described in
this manual. Never remove the motor hood un-
less instructed to do so by an authorized ser-
vice representative. Servicing other than the
procedures in this manual should be performed
by an authorized service representative only.
26. This treadmill is intended for in-home use
only. Do not use this treadmill in a commer-
cial, rental, or institutional setting.
4
b. If the walking belt slips when walked on, remove
the key and UNPLUG THE POWER CORD. Using the
hex key, turn both rear roller bolts clockwise, 1/4 of a
turn. When the walking belt is correctly tightened, you
should be able to lift each edge of the walking belt 5–7
cm (2–3 in.) off the walking platform. Be careful to keep
the walking belt centred. Then, plug in the power cord,
insert the key, and walk on the treadmill for a few min-
utes. Repeat until the walking belt is properly tight-
ened.
PROBLEM: The chest pulse sensor does not function properly
SOLUTION: a. If the chest pulse sensor does not function properly, see CHEST PULSE SENSOR TROUBLE-
SHOOTING on page 9.
b. If the chest pulse sensor still does not function properly, the battery
should be changed. To replace the battery, first locate the battery
cover on the back of the sensor unit. Insert a coin into the slot in the
cover, and turn the cover counterclockwise to the "open" position.
Then, remove the cover.
Next, remove the old battery from the sensor unit, and insert a new
CR 2032 battery, with the battery oriented so the writing is on
top. Make sure that the rubber gasket is in place in the sensor unit.
Then, reinsert the battery cover and turn it to the closed position.
PROBLEM: The incline of the treadmill does not change correctly
SOLUTION: a. With the key in the console, press one of the Incline buttons. Whilst the incline is changing, re-
move the key. After a few seconds, reinsert the key. The treadmill will automatically rise to the
maximum incline level and then return to the minimum level. This will recalibrate the incline system.
b
b
Battery Cover
Battery
Cover
Battery
Rubber
Gasket
29
Advertisement
