Good Earth Lighting UC1360-WHG-12LFW Quick Start Manual

TAP/ON/OFF/HOLD TO DIM Button Color Adjust/ WIFI Button
TAP/ON/OFF/HOLD TO DIM Bouton Bouton de réglage blanc/WIFI
Botón TAP/ON/OFF/HOLD TO DIM Botón de ajuste de blanco/WIFI
Screw Cover
Brides de cordon
Cubierta de tornillos
Required/ Nécessaire/ Obligatorio
* Actual hardware may differ from illustration./ * La quincaillerie incluse peut être différente de l'illustration./ * Los aditamentos reales pueden diferir de los que se muestran en la ilustración.
READ ENTIRE INSTALLATION PROCEDURE BEFORE YOU BEGIN!
ATTENTION
Use only insulated staples or plastic ties to secure the cords.
Route and secure the cords so that they will not be pinched
or damaged.
LEDs gradually emit less light over their lifetime.
Only the bars (Model #UC1360-WHG-12LFW/
UC1360-WHG-24LFW ) can be linked to undercabinet
bara. 20 additional bars can be added to the 12 inch
bar, and 10 to the 24 inch bar.
Suitable for INDOOR damp locations ONLY.
EASY INSTALLATION COMMAND® STRIPS BY 3M
1
2
SLOWLY
Barre à DEL WIFI pour installation sous un meuble (Página 3)
Barra LED WIFI para debajo de gabinetes (Page 5)
Model / Model / Modelo #: UC1360-WHG-12LFW, UC1360-WHG-24LFW-G
Di user
Di useur
Difusor
x2 x2
ENGLISH INSTRUCTIONS
SAFETY INFORMATION
WARNING
LED light output is strong enough to injure human
eyes. Do not look directly at exposed LEDs.
Turn power o before servicing.
Ensure cords are unplugged when securing or
moving.
30
sec
Use the 2 included clear cord clips for cord management. To apply,
2
clean surface with rubbing alcohol. Use the 2 additional small strips
for cord clips. Remove red liners. Press the strips to the back of the
clip. Remove black liners. Press each clip firmly to the surface for 30
sec. Insert cords into cord clips and plug into outlet.
30
sec
REMOVAL
SAVE AND ATTACH RECEIPT HERE
WIFI LED Undercabinet Bar (Page 1)
Screw Cover
Brides de cordon
Cubierta de tornillos
x2
CAUTION
DO NOT USE THIS FIXTURE WITH A DIMMING CIRCUIT.
Do NOT use with an extension cord, use ONLY with power strips that have integral
overcurrent protection.
Do NOT mount to surfaces less than ¼ in. thick.
A. For installation with Command® Strips by 3M: Do NOT mount over sinks,
stoves, beds or inside of enclosed cabinets. Do NOT mount on wallpaper.
B. For installation using screws: Do NOT mount over sinks, stoves, or inside of
enclosed cabinets.
Not intended for recessed installation in ceiling or so ts.
NOTE: Ensure mounting location is within
1
5ft. of an electrical outlet. Clean surface
with rubbing alcohol. Remove red liners.
Press two medium strips to the back of
the 12in fixture, and three on the 24in.
fixture. Remove black liners. Press the
fixture to surface with tab towards you.
Press firmly for 30 sec.
Gently hold the light or clip in
place with one hand. NEVER
PULL THE STRIP AWAY FROM
THE SURFACE! Always pull
along the surface. Slowly
stretch each strip slowly
against the surface at least 12
inches to release.
Linking cord
Cordon de raccordement
Cable de enlace
Power cord
Cordon d'alimentation
Cable de alimentación
UC1360-WHG-12LFW
x2
x3 UC1360-WHG-24LFW