Good Earth Lighting UC1208-AL3-12LF5-G Quick Start Manual

Linking cord
Cordon de raccordement
Cable de enlace
Back touch button
Bouton poussoir arrière
Botón táctil trasero
Back light
Éclairage arrière
Luz trasera
DO NOT ATTEMPT TO INSTALL LED LIGHT BAR WHILE PLUGGED IN.
This LED Light bar has a 3-prong grounded plug as a feature to reduce the risk of electric shock. This plug will fit in a grounded outlet only one way. If the plug does not
fit fully in the outlet, contact a qualified electrician. Never use power strip unless the plug can be fully inserted. Do not alter the plug.
DO NOT USE THIS FIXTURE WITH A DIMMING CIRCUIT.
Read entire installation procedure before you begin and save instructions close to the fixture for future reference.
IMPORTANT SAFETY INFORMATION
1. Use only insulated staples or plastic ties to secure the cords.
2. Route and secure the cords so that they will not be pinched or damaged.
3. LED light output is strong enough to injure human eyes. Do not look directly at exposed LEDs.
4. LEDs gradually emit less light over their lifetime.
5. Do not use an extension cord. Use power strips with integral overcurrent protection to supply other electrical devices or accessories in cabinet.
6. Suitable for INDOOR damp locations.
7. Do NOT mount to surfaces less than ¼ in.
8. Do NOT mount over sinks or stoves.
9. Do NOT install these lights inside of enclosed cabinets.
10. Turn power off before servicing.
11. Maximum number of fixtures per run must not exceed maximum power supply wattage rating of 240W.
12. Not intended for recessed installation in ceiling or soffits.
Care and Maintenance
Periodically clean the fixture and diffuser using a mild, non-abrasive cleaner and soft cloth. When cleaning the fixture, make sure the power is turned off. Do not spray
cleaner directly onto any part of the fixture or LEDs.
CCx2
Remove screw covers (CC) on both ends. Mark the general area where fixture will be mounted. Using a small drill or nail, make two small pilot holes at the marked locations.
NOTE: Ensure mounting location is within 5ft. of an electrical outlet.
Hold the fixture in the marked location and drive wood screws (AA) until they contact the bottom surface of the cabinet. The wood screws (AA) must be driven in straight for the
fixture to mount properly. DO NOT OVERTIGHTEN to prevent stripping the screw hole. Replace screw covers (CC) on both ends.
Insert power cord connector into the end of the fixture. Insert plug into an electrical outlet. Use included cord clips (BB) for cord management.
Barre d'éclairage à DEL pour raccordement pour dosseret à mains libres (Page 2)
Barra LED enlazable manos libres para protección antisalpicaduras (Página 4)
Power cord
Cordon d'alimentation
Cable de alimentación
Front light hands free controls
Commandes de l'éclairage à l'avant à mains libres
Controles de la luz delantera manos libres
WARNINGS AND CAUTIONS
AAx2
CCx2
LED Handsfree Backsplash Linking Bar (Page 1)
UC1208-AL3-12LF5-G, UC1208-AL3-18LF7-G, UC1208-AL3-24LF1-G
Front light
Éclairage avant
Luz delantera
BBx3
Model / Model / Modelo #:
AAx2 BBx3
* Actual hardware may differ from illustration
* La quincaillerie incluse peut être différente de
l'illustration.
* Los aditamentos reales pueden diferir de los
que se muestran en la ilustración.
Required/ Nécessaire/ Obligatorio
CCx2