KING Jack Classic OA8120/21 Series Troubleshooting Manual

KING Jack Classic OA8120/21 Series Troubleshooting Manual

Digital hdtv over-the-air antennas

Advertisement

Quick Links

TROUBLESHOOTING GUIDE
Digital HDTV Over-the-Air Antennas
11200 Hampshire Avenue South, Bloomington, MN 55438
PH 952.922.6889 || FAX 952.922.8424 || kingconnect.com
Classic KING Jack
OA8120/21 Series
OA8200/01 Series
OA8220/21 Series
KING Jack
OA8400/01 Series
OA8500/01 Series

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Classic OA8120/21 Series and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for KING Jack Classic OA8120/21 Series

  • Page 1 TROUBLESHOOTING GUIDE Digital HDTV Over-the-Air Antennas Classic KING Jack OA8120/21 Series OA8200/01 Series OA8220/21 Series KING Jack OA8400/01 Series OA8500/01 Series 11200 Hampshire Avenue South, Bloomington, MN 55438 PH 952.922.6889 || FAX 952.922.8424 || kingconnect.com...
  • Page 3: Table Of Contents

    REPLACE ANTENNA HEAD (Classic KING Jack) ........18-19...
  • Page 4: Introduction (All Jacks)

    • Issue a Service Order Number (if any work is to be performed or parts replaced). IMPORTANT! For warranty reimbursement, you must call KING for a Service Order Number BEFORE performing any work: (952) 922-6889. KING Jack Serial number located here Serial number located here Classic KING Jack Page 2...
  • Page 5: Warranty Information (All Jacks)

    WARRANTY INFORMATION (All Jacks) Section 2 KING Jack Antennas are covered by a limited warranty from the date of original purchase. KING Jack ......Four-year parts and one-year labor Classic KING Jack ....Two-year parts and one-year labor This warranty does not cover installation, external wiring, refurbished units or the following: •...
  • Page 6: Wall Mount Power Injector Operation (All Jacks)

    3. Press button and turn knob to rotate antenna in one direction until it hits the stop. 4. Rotate attenuator dial fully clockwise. KING Jack shown. Arrow on knob indicates which direction antenna is pointing. 5. Rotate antenna a full 360 degrees.
  • Page 7: Aiming The Antenna: Without Meter (All Jacks)

    Note the number of channels received. 6. Press button and rotate antenna 90 degrees. Scan again. Note the number of channels received. 7. Reposition your KING Jack antenna to where you received the most channels. Choose one of those channels on your TV. Now monitor the signal strength screen and fine tune the KING Jack until the highest signal strength is achieved. Perform one final scan.
  • Page 8: Flowchart Reference Diagrams (King Jack)

    FLOWCHART REFERENCE DIAGRAMS (KING Jack) Section 6 Page 6...
  • Page 9 Page 7...
  • Page 10: Flowchart Reference Diagrams Classic King Jack)

    FLOWCHART REFERENCE DIAGRAMS (Classic KING Jack) Section 7 Page 8...
  • Page 11 Page 9...
  • Page 12: Troubleshooting Flowchart (All Jacks)

    TROUBLESHOOTING FLOWCHART (All Jacks) Section 8 Page 10...
  • Page 13 Page 11...
  • Page 14: Flowchart Error Codes (All Jacks)

    Section 10 PART # Description 21631 ..Ceiling enclosure with signal meter 20954 ..Antenna Head (White) Classic KING Jack 21053 ..Antenna Head (Black) Classic KING Jack 22529 ..Antenna Head (White) KING Jack 22530 ..Antenna Head (Black) KING Jack 20263B ..
  • Page 15: Block Times (All Jacks)

    BLOCK TIMES (All Jacks) Section 11 REPLACEMENT PROCEDURE TIME IN MINUTES Power Injector Signal Meter Antenna Head KING Jack Assembly NOTE: See sections 12-17 for detailed instructions. Page 13...
  • Page 16: Replace Power Injector (All Jacks)

    REPLACE POWER INJECTOR (All Jacks) Section 12 NOTE: Make sure power to power injector is turned off before proceeding. Page 14...
  • Page 17: Replace Signal Meter (All Jacks)

    REPLACE SIGNAL METER (All Jacks) Section 13 NOTE: Turn off power injector before proceeding. Page 15...
  • Page 18: Replace Antenna Head (King Jack)

    REPLACE ANTENNA HEAD (KING Jack) Section 14 NOTE: Turn off power injector before proceeding. Page 16...
  • Page 19 This page intentionally left blank. Page 17...
  • Page 20: Replace Antenna Head (Classic King Jack)

    REPLACE ANTENNA HEAD (Classic KING Jack) Section 15 NOTE: Turn off power injector before proceeding. Page 18...
  • Page 21 Page 19...
  • Page 22: Replace King Jack Assembly (King Jack)

    REPLACE KING JACK ASSEMBLY (KING Jack) Section 16 NOTE: Turn off power injector before proceeding. Page 20...
  • Page 23 IMPORTANT! Coax channel must face towards rear of vehicle. Page 21...
  • Page 24: Replace King Jack Assembly (Classic King Jack)

    REPLACE KING JACK ASSEMBLY (Classic KING Jack) Section 17 NOTE: Turn off power injector before proceeding. Page 22...
  • Page 25 Page 23...
  • Page 26: Warranty Consideration Form (All Jacks)

    Page 24...
  • Page 28 Simply better, by design. ™ 11200 Hampshire Avenue South, Bloomington, MN 55438 PH 952.922.6889 || FAX 952.922.8424 || kingconnect.com © 2017 KING 22412 Rev D, KING Jack Antenna Troubleshooting Guide...

Table of Contents