Connect To Wi-Fi Networks (For Selected Models) - Lenovo ThinkEdge SE10 User Manual

$ sudo nmcli con mod <connection name> ipv4.dns
$ sudo nmcli con mod <connection name> ipv4.method manual
$ sudo nmcli con up
If you want to go back to a dynamic IP by DHCP, use the following commands.
$ sudo nmcli con down <connection name>
$ sudo nmcli con mod <connection name> ipv4.method auto
$ sudo nmcli con up

Connect to Wi-Fi networks (for selected models)

If your computer includes a wireless LAN module, you can connect your computer to Wi-Fi networks. The
wireless LAN module on your computer may support different standards. For some countries or regions, use
of 802.11ax may be disabled according to local regulations.
The easiest way to connect to Wi-Fi is using n n m m c c l l i i command. Steps may vary depending on your wireless
access point. Use the following commands to scan available SSIDs and configure the Wi-Fi port accordingly.
1. Check and confirm if Wi-Fi is enabled.
$ nmcli r wifi
$ nmcli r wifi on
2. Scan available Wi-Fi list.
$ nmcli dev wifi list
28
ThinkEdge SE10 User Guide
<connection name>
<connection name>
<xx.xx.xx.xx>