Toshiba MMW-AP0481CHQ-E Service Manual page 32

4
Push the TIME
SET DATA.
Change the value in SET DATA to that of a new address.
5
Push the button to confirm the new address on SET DATA.
6
Push the
UNIT LOUVER
change.
Each time you push the button, the indoor unit numbers in a refrigerant line are indicated
one after another. Only the fan and louvers of the selected indoor unit are activated.
4
Repeat steps to
7
Push the button.
(All the segments on the LCD display light up.)
8
Push the button to finish the procedure.
NOTE:
The LED on the P.C. board of the selected hot water module flashes. The hot water module for change
settings can be confirmed.
TEMP.
4
FILTER
RESET TEST
8
Finish
5, 7
/ buttons repeatedly to change the value of the indoor unit address in
button (left side of the button) repeatedly to select another address to
6
to change the indoor unit addresses so as to make each of them unique.
CODE NO.
ON / OFF
TIMER SET FAN MODE
TIME SAVE VENT
SET CL SWING/FIX UNIT LOUVER
Press to finish setting
– 32 –
6