Table of Contents
Advertisement
M.2 socket 3
This socket allows you to install an M.2 (NGFF) SSD module. Use the bundled
screw 13020-0181000 to secure your M.2 device.
Clear RTC RAM (2-pin CLRTC)
This header allows you to clear the CMOS RTC RAM data of
the system setup information such as date, time, and system
passwords.
To erase the RTC RAM:
1.
2.
3.
4.
Intel
®
This jumper allows you to enable or disable the Intel
to pins 1-2 to enable (default) the Intel
Front panel audio connector (10-1 pin AAFP)
This connector is for a chassis-mounted front panel audio I/O module that supports
HD Audio. Connect one end of the front panel audio I/O module cable to this
connector.
DMIC connector (5-1 pin DMIC)
The DMIC connector is for connecting the digital microphone module used in All-
in-One chassis.
Internal stereo speaker header (4-pin SPK_OUT)
24
The internal mono speaker header allows connection to an internal, low-power
speaker for basic system sound capability. The subsystem is capable of driving a
speaker load of 4 Ohms at 3 Watts (rms).
Chapter 1: Product introduction
E11582_Q170T_UM.indb 4
This socket supports M Key and 2242/2260/2280 storage devices.
Turn OFF the computer and unplug the power cord.
Use a metal object such as a screwdriver to short the two
pins.
Plug the power cord and turn ON the computer.
Hold down the <Del> key during the boot process and
enter BIOS setup to re-enter data.
If the steps above do not help, remove the onboard battery and short the two pins again
to clear the CMOS RTC RAM data. After clearing the CMOS, reinstall the battery.
ME jumper (3-pin DIS_ME)
Disable the Intel
ME function before updating it.
®
We recommend that you connect a high-definition front panel audio module to this
connector to avail of the motherboard's high-definition audio capability
ME function. Set this jumper
®
ME function and to pins 2-3 to disable it.
®
CLRTC
PIN 1
1-4
2016-05-05 10:16:51
Advertisement
Table of Contents
