Dell Dimension 2400 Series Manual page 37

NOTICE: To disconnect a network cable, first unplug the cable from your computer and then unplug it from the network wall jack.
10. Turn off any attached devices and disconnect them from their electrical outlets.
11. Disconnect the computer power cable from the wall outlet, and then press the power button to ground the system board.
12. Remove the computer cover.
13. Remove the password jumper.
Attach the jumper to only one pin so that you do not lose it.
14. Replace the computer cover.
NOTICE: To connect a network cable, first plug the cable into the network wall jack and then plug it into the computer.
15. Connect your computer and devices to electrical outlets, and turn them on.
16. If you are prompted to press <F1> to continue, press <F1>.
Back to Contents Page