PowerXL ES2416S 05 Owner's Manual page 9

Instructions for Use
NOTE: Some water can get trapped inside
the cap and come out of the small air hole
when the iron is held vertically. This is not a leak;
simply open the cap and empty out any residual
water. Also, there can sometimes be a noise
created by air being vented through the air hole
in the cap. If this occurs, simply open the cap to
stop the noise.
2. Plug the Base into a grounded wall socket and
switch the Unit on. Make sure the steam is set to
Off while the Iron is heating.
NOTE: When used with the cord, the light will
go on and off as the temperature regulates.
When used cordlessly, the iron should be placed
back on the Base Unit to maintain heat. When
the thermostat light is off, the iron is ready.
Dry Ironing
To dry iron, turn the temperature Control Dial to
the desired setting and turn the Steam Selector
to the "off" position.
Spray Function
To use the Spray Function, first ensure that there is
water in the tank. Then, press the Spray button
(#5, p. 6) slowly (for a dense spray) or quickly (for
a vaporized spray).
WARNING: For delicate fabrics, we recommend
moistening the fabric beforehand using the
Spray Button or putting a damp cloth between the
iron and the fabric. To avoid staining, do not use
the spray on silk or synthetic fabrics.
Using the Steam Blast
Trigger and Steam Ironing
Vertically
Set the Steam Selector to the closed position to
maintain the pressure for the steam blast function.
After the iron has fully heated, press the Steam
Blast Trigger (#6, p. 6) to generate a powerful burst
of steam that can penetrate fabrics and smooth
difficult creases. Wait for at least 2 seconds before
pressing again.
WARNING: The Steam Blast Trigger function can
only be used at high temperatures. Remember to
place the iron on the base periodically when using
the iron cordlessly. Once the temperature light
is off, remove from the base and continue to steam.
Always read the care label.
PowerXL Cordless Iron & Steamer Deluxe | Model: ES2416S_05
9