Troubleshooting - PowerXL ES2416S 05 Owner's Manual

Troubleshooting

Symptom
Iron is not hot.
Water is leaking from the
holes in the soleplate.
The soleplate is dirty or brown
and can stain the linen.
There is little to no steam.
Brown streaks come through the
holes in the soleplate and stain the linen.
Twisted cord.
14
PowerXL Cordless Iron & Steamer Deluxe | Model: ES2416S_05
Possible Cause
The iron is not plugged in.
You have not selected a temperature.
The Automatic Shut-Off is activated.
Water exceeds the Max line.
Steam button was pressed while the
iron was not hot enough.
You have stored the iron horizontally without
emptying it and without setting it to
The Steam Selector was moved to the
open position.
You are ironing at an inappropriate temperature
selection (temperature too high).
You have ironed over a printed area of a garment.
The Water Tank is empty or not full enough.
Your iron has been used dry for too long.
The iron is not hot enough.
The Anti-Drip Feature is on.
You are using ironing water additives
(i.e. scented water, starch).
Solution
Plug the Power Cable into a working outlet.
Turn the Temperature Control Dial to the desired
temperature and the iron will begin to heat.
Lift the iron horizontally and back to the verticle position to
deactivate the safety feature (indicated by a constant blue
light). The iron will begin to heat again.
Pour water out of the Water Tank until the water level is
below the Max line.
Wait a few seconds between each use of the button.
Refer to the Storage section on p. 12.
.
If dry ironing, make sure the steam lever is set to the
"No Steam" function (
Clean the soleplapte (refer to the Care & Cleaning section
on p. 12.
Never iron over printed areas. Always iron the reverse side
of such garments.
Fill the Water Tank.
Carry out a Self-Cleaning cycle.
Preheat for 2 minutes
The Anti-Drip Feature will not allow steam when the
temperature is set within the dry range.
Never use ironing additives; these will permanently
damage your steam iron.
If the Power Cord becomes twisted, unplug the iron and
let it cool. Hold the middle of the Power Cord. Let the
Power Cord and Unit Base dangle freely until the Power
Cord uncoils. This will extend the life of the Power Cord.
).