Table of Contents
Advertisement
Get started
Remove the memory card
Important: Do not remove the memory card in the middle of an operation when
the card is being accessed. Removing the card in the middle of an operation may damage
the memory card as well as the device, and data stored on the card may be corrupted.
You can remove or replace the memory card during phone operation without switching
the device off.
1. Ensure that no application is currently accessing the memory card.
2. Remove the back cover.
3. Press the memory card slightly in to release the lock and remove it.
4. Replace the back cover.
Charge the battery
1. Connect the charger to a wall socket.
2. Connect the lead from the charger to the charger connector of
your phone.
If the battery is completely discharged, it may take a few minutes
before the charging indicator appears on the display or before any
calls can be made.
The charging time depends on the charger used. Charging a BL-4S
battery with the AC-4 charger takes approximately 1 hour 30
minutes while the phone is in the standby mode.
Antenna
Your device may have internal and external antennas. As with any radio
transmitting device, avoid touching the antenna area unnecessarily while
the antenna is transmitting or receiving. Contact with such an antenna
affects the communication quality and may cause the device to operate at
a higher power level than otherwise needed and may reduce the battery
life.
The figure shows the antenna area marked in grey.
12
Cyan
Cyan
Magenta
Magenta
Yellow
Yellow
Black
Black
Advertisement
Table of Contents
