Table of Contents
Advertisement
7.7 Switching on the fan run-on
During the fan run-on, the appliance continues to run
for a short time and then switches off automatically.
▶
Press
or slide in the filter pull-out.
a The appliance switches off automatically after ap-
prox. 10 minutes.
7.8 Switching on the lighting
The lighting can be switched on and off independently
of the ventilation system.
▶
Press
.
7.9 Setting the brightness
▶
Press and hold
until the required brightness is
reached.
7.10 Switching on the audible signal
Requirement: The appliance is switched off.
▶
Press and hold
and
prox. three seconds until a signal sounds.
7.11 Switching off the audible signal
Requirement: The appliance is switched off.
▶
Press and hold
and
prox. three seconds until a signal sounds.
7.12 Saturation indicator
If the grease filters or odour filters are saturated, cor-
responding symbols flash after the appliance is
switched off.
Clean the saturated grease filters and, in doing so, ob-
serve the cleaning instructions in these instructions.
8 Cleaning and servicing
To keep your appliance working efficiently for a long
time, it is important to clean and maintain it carefully.
8.1 Cleaning products
You can obtain suitable cleaning products from after-
sales service or the online shop.
WARNING ‒ Risk of electric shock!
An ingress of moisture can cause an electric shock.
Before cleaning, pull out the mains plug or switch
▶
off the fuse in the fuse box.
Do not use steam- or high-pressure cleaners to
▶
clean the appliance.
WARNING ‒ Risk of burns!
The appliance becomes hot during operation.
Allow the appliance to cool down before cleaning.
▶
ATTENTION!
Unsuitable cleaning products may damage the sur-
faces of the appliance.
▶
Do not use harsh or abrasive detergents.
at the same time for ap-
at the same time for ap-
Change the saturated odour filters and observe the in-
structions in the accompanying instructions.
If odour filters can be regenerated, follow the instruc-
tions in the accompanying instructions.
7.13 Resetting the saturation indicator
After cleaning the grease filter or after changing the
odour filter, the saturation indicator can be reset.
Requirements
¡ After the appliance has been switched off,
pears in the display for the grease filter.
¡ After the appliance has been switched off,
pears in the display for the odour filter.
¡ A signal sounds repeatedly.
▶
Press
.
a The saturation indicator is reset.
7.14 Setting the saturation indicator
The saturation indicator must be adjusted depending
on the filter used.
Requirement: The appliance is switched off.
1.
To set circulating-air mode for the standard odour
filter, press and hold
the display.
2.
To set circulating-air mode for the CleanAir standard
odour filter or the CleanAir Plus odour filter, press
and hold
and
repeatedly until
the display.
3.
To set the exhaust-air mode, press and hold
repeatedly until
▶
Do not use cleaning products with a high alcohol
content.
▶
Do not use hard scouring pads or cleaning
sponges.
▶
Only use glass cleaners, glass scrapers or stainless
steel care products if recommended in the cleaning
instructions for the relevant part.
▶
Wash sponge cloths thoroughly before use.
Cleaning and servicing en
and
until
appears in
appears in
appears in the display.
ap-
ap-
and
7
Advertisement
Table of Contents
