Cleaning And Servicing - Siemens LC 5KDK6K Series User Manual And Installation Instructions

After cleaning the grease filter and/or changing the
odour filter, the saturation indicator should be reset.
Resetting the saturation indicator
Requirement: The appliance is switched on.

Cleaning and servicing

8 Cleaning and servicing
To keep your appliance working efficiently for a long
time, it is important to clean and maintain it carefully.
8.1 Cleaning products
You can obtain suitable cleaning products from after-
sales service or the online shop.
ATTENTION!
Unsuitable cleaning products may damage the sur-
faces of the appliance.
Do not use harsh or abrasive detergents.
▶
Do not use cleaning products with a high alcohol
▶
content.
Do not use hard scouring pads or cleaning
▶
sponges.
Only use glass cleaners, glass scrapers or stainless
▶
steel care products if recommended in the cleaning
instructions for the relevant part.
Wash sponge cloths thoroughly before use.
▶
8.2 Cleaning the appliance
Clean the appliance as specified. This will ensure that
the different parts and surfaces of the appliance are
not damaged by incorrect cleaning or unsuitable clean-
ing products.
WARNING ‒ Risk of explosion!
Highly caustic alkaline or highly acidic cleaning agents
in conjunction with aluminium parts in the interior of the
appliance may cause explosions.
Never use highly caustic alkaline or highly acidic
▶
cleaning agents. In particular, do not use commer-
cial or industrial cleaning agents in conjunction with
aluminium parts, e.g. grease filter on extractor
hoods.
WARNING ‒ Risk of electric shock!
An ingress of moisture can cause an electric shock.
Before cleaning, pull out the mains plug or switch
▶
off the fuse in the fuse box.
Do not use steam- or high-pressure cleaners to
▶
clean the appliance.
WARNING ‒ Risk of burns!
The appliance becomes hot during operation.
Allow the appliance to cool down before cleaning.
▶
WARNING ‒ Risk of injury!
Components inside the appliance may have sharp
edges.
Carefully clean the appliance interior.
▶
Observe the information regarding the cleaning
1.
agents.
Clean as follows, depending on the surface:
2.
Press and hold for 3 seconds.
▶
a The saturation indicator is reset.
a or stops flashing.
Clean stainless steel surfaces in the direction of
‒
the finish using a sponge cloth and hot soapy
water.
Clean painted surfaces using a damp sponge
‒
cloth and hot soapy water.
Clean aluminium using a soft cloth and glass
‒
cleaner.
Clean plastic using a soft cloth and glass
‒
cleaner.
Clean glass using a soft cloth and glass cleaner.
‒
Dry with a soft cloth.
3.
4. Apply a thin layer of the stainless steel cleaning
product to stainless steel surfaces using a soft
cloth.
You can obtain stainless steel cleaning products
from the after-sales service or the online shop.
8.3 Cleaning controls
WARNING ‒ Risk of electric shock!
Penetrating moisture may cause an electric shock.
Do not use wet sponge cloths.
▶
1. Observe the information regarding the cleaning
agents.
Clean using a damp sponge cloth and hot soapy
2.
water.
Dry with a soft cloth.
3.
8.4 Opening the glass flap
Hold the glass flap at the lower edge and pull it up-
▶
wards.
Slide the opened glass flap slightly to the rear.
‒
a The hinges click into place and the glass flap re-
mains open.
8.5 Closing the glass flap
Slightly raise the glass flap and pull it forwards in or-
1.
der to loosen the securing position of the hinges.
Cleaning and servicing en
21