inVue ZA2720-W Manual

Zips
ZA2720-W Merchandising
Guide
3

Remove the Pencil from the sensor.

1a Use a charged and coded OneKEY
to deactivate the inVue product that
the sensor is plugged into. For Zips
Alarm Units, place the OneKEY onto
the IR lens and press the button.
Then place the magnet key onto the
lock icon on alarm unit above the
sensor. Push in slightly and unplug
the sensor.
1
2
4 If reinstalling the Pencil, use an
alcohol wipe to remove any adhesive
residue. Allow it to dry completely.
1b If using the S2865 system, place the
charged and coded OneKEY onto
the Remote IR Dot connected to the
system and press the button. Remove
the sensor from the S2865 Alarm/
Power Box.
5 Remove the old adhesives from the
sensor.
2 Gently pry open the flexibles sides
of the ZA2720 sensor to break the
adhesive bond between the sensor
and the Apple Pencil.
6 Use an alcohol wipe to remove any
adhesive residue from the inside
of the sensor. Use caution to not
damage the micro switch inside of
the sensor. Allow it to dry completely.