Operation - homelabs HME020379N Instructions Manual

Operation

INSTALLATION
Your installation location should meet the following requirements:
• Make sure that you install your unit on an even surface for minimal noise and vibration.
• The unit must be installed near a grounded plug and the Bottom Tray Drain Outlet (on the back of the unit) must be accessible.
• The side of this unit should be at least 12 in (30 cm) from a wall or obstruction to ensure proper air flow.
• Do not cover the Intakes, Outlets, or Remote Signal Receptor of the unit, as this could cause damage to the appliance.
• In addition, the top and back of the AC unit should be at least 19.7 in (50 cm) away from a wall or obstruction.
WINDOW INSTALLATION KIT
TOOLS NEEDED: • Medium Philips screwdriver • Knife or scissors
• Tape measure or ruler • Saw (optional, to shorten Window Slider Adapter for narrow windows)
1. Preparing the Exhaust Hose Assembly
Keep the gray, foam tabs on each corner of the Window Slider Adapter in place as assembled. Press the Exhaust Hose into the
Window Slider Adapter and Unit Adapter. They will clamp together automatically by the elastic buckles of the Adapters. You will
hear all 4 corners click once the unit is properly assembled.
Window Slider
Exhaust Hose
Unit Adapter
2. Installing the Exhaust Hose Assembly to the Unit
Insert the Unit Adapter (the Unit Adapter hook should remain right-side up) of the Exhaust Hose assembly into the lower
groove of the Air Outlet while the hook of the Adapter is aligned with the Air Outlet. Slide down the Unit Adapter. The Hose will
slide in and lock in place.
Hook Hole Seat
19.7 in
(50 cm)
Adapter
Assembled Exhaust Hose
Adapter Lower Groove
Make sure the Adapter is inserted into
the lower groove of the Air Outlet.
16
Operation
INSTALLATION
3. Preparing the Adjustable Window Slider
• Based on the size of your window, adjust the size of the Window Slider.
• If the length of the window requires two Window Sliders, use the Bolt to fasten the Window Sliders once they are
adjusted to the proper length.
NOTE:
Your Window Installation Kit fits windows 26.5–48 in (67.5–123 cm) and can be shortened for smaller windows.
Bolt
Window Slider A
NOTE:
Once the Exhaust Hose assembly and Adjustable Window Slicer are prepared, choose from one of the following two
installation methods. (For Type 2: See page > 18)
TYPE 1: Hung Window Installation
1. Cut Foam Seal A and B strips to the proper lengths and remove the adhesive backing. Attach them to the window sash
and frame as shown.
2. Insert the Window slider assembly into the window opening.
3. Cut the non-adhesive Foam Seal C strip to match the width of the window. Insert the seal between the glass and the window
frame to prevent air and insects from getting into the room.
4. OPTIONAL: Install the security bracket with 2 screws as shown.
5. Insert the Window Slider Adapter into the hole of the Window Slider.
Foam Seal B
(Adhesive type-shorter)
Foam Seal A
(Adhesive type)
Security Bracket
2 Screws
NOTE:
To ensure proper functioning, do not over-extend or bend the Hose. To ensure the exhaust system works properly,
make sure that there is no obstacle around the Air Outlet of the Exhaust Hose (in the range of 19.68 in or 500 mm).
Window Slider B
Foam Seal C
(Non-adhesive type)
B
A (if required)
17 17