Table of Contents
Advertisement
Parts Overview
PREPARATION
All the illustrations in the manual are for explanation purpose only. Your machine may be slightly different. The actual shape will
prevail. The unit can be controlled by the unit Control Panel alone or with the Remote Controller. This manual does not include
Remote Controller Operations.
See Page > 22 for Remote Controller details.
Control Panel
Horizontal Louver Blade
(Swing Automatically)
Handle
(Both Sides)
Remote Signal
Receptor
Panel
Caster
Front
DESIGN NOTICE
In order to ensure the optimal performance of our products, the design specifications of the unit and Remote Controller are subject
to change without prior notice.
AMBIENT TEMPERATURE RANGE FOR UNIT OPERATING
MODE
TEMPERATURE RANGE
Cool
62–95°F (17–35°C)
Dry
55–95°F (13–35°C)
EXHAUST HOSE INSTALLATION
The Exhaust Hose and Adapter must be installed or removed in accordance with the usage mode.
• For "Cool", "Heat" (heat pump type) or "Auto" mode must be installed Exhaust Hose.
• For "Fan", "Dry" or "Heat" (electrical heat type) mode must be removed Exhaust Hose.
See Page > 14–16 for more details.
Upper Air Filter
(Behind the Grille)
Upper Air Intake
Drain Outlet
Air Outlet
Lower Air Filter
Lower Air Intake
Power Plug Socket
Drain Outlet (Only for
Pump Heating Mode)
Power Cord Buckle
Power Cord Outlet
Bottom Tray
Drain Outlet
Rear
MODE
TEMPERATURE RANGE
Heat (pump heat mode)
41–86°F (5–30°C)
Heat (electrical heat mode)
86°F (≤ 30°C)
12
Installation Instructions
CHOOSING THE RIGHT LOCATION
Your installation location should meet the following requirements:
• Make sure that you install your unit on an even surface to minimize noise and vibration.
• The unit must be installed near a grounded plug, and the Collection Tray Drain
(found on the back of the unit) must be accessible.
• The unit should be located at least 12 in (30 cm) from the nearest wall to ensure proper
air conditioning. The horizontal louver blade should be at least 19.7 in (50 cm)
away from obstacles.
CAUTION:
Do not cover the Instakes, Outlets or Remote Signal Receptor
of the unit, as this could cause damage to the unit.
RECOMMEND INSTALLATION
ENERGY RATING INFORMATION
The energy rating and noise information for this unit is based on the standard installation using an un-extended
exhaust duct (Diameter: 150 mm, Length: 1.5 m) without Window Slider Adapter or Wall Exhaust Adapter A.
The unit with 3 meters extended exhaust duct is running by using 2 exhaust ducts (Diameter: 150 mm,
Length: 1.5 m + Diameter: 130 mm, Length: 1.5 m). The Energy rating and noise information for unit with
3 meters extended exhaust duct is not assessed. (For some models).
NOTE:
We recommend that operating the unit at room temperature below 95°F (35°C). Since there is a risk that
the unit with 3 meters extended exhaust duct would not work at room temperature above 95°F (35°C)
under some extreme conditions, such as the Lower Air Intake be blocked for 50%.
13
Advertisement
Table of Contents
