Table of Contents
Advertisement
STEP 13 - Install Side Panels
• Install with the drip edge down and align the
half-moon cutouts on the side panel with the inlet
and outlet fasteners
• Fasten the side panels to the fan with the provided
Bottom
self-tapping sheet metal screws
• Sizes 18-33 have two (2) panels per side, which
are fastened to the mullions and to the inlet and
outlet plates
SIZE 7-16
STEP 14 - Mount Disconnect Switch (if applicable)
• Determine ideal location for the disconnect switch
• Install disconnect per manufacturer's suggestions
STEP 15 - Install Conduit
• Connect the provided flexible metal conduit (FMC) to
the power junction box
• Route the opposite end of the conduit assembly with
the female connector to the hole in end cap
• Insert the liquid-tight connector into the hole in the end
cap and screw into the female connector, as shown
• Cut the liquid-tight conduit (supplied by others) to
length, and install from the elbow to the disconnect
switch or power supply
®
Top
SIZE 7-16
SIZE 7-16
Foam Tape
SIZE 7-16
STEP 16 - Route Wiring to Junction Box
• Route the wiring from the junction box to the
disconnect through all conduit
• Junction boxes (and "Dial on Fan" if Vari-Green
top of the fan are inaccessible when outdoor cover is
fully installed
STEP 17 - Install Top Panel(s) of Cover
• TAKE CARE NOT TO DAMAGE THE FOAM TAPE ON
THESE PARTS
SIZE 7-16
• Size 7-16:
Install the top panel of the outdoor cover to the fan
using the provided self-tapping sheet metal screws
Top
Bottom
SIZE 18-33
• Sizes 18-33:
1. Install the first top panel with the single return flange
using the provided self-tapping sheet metal screws
(reference 1)
2. Install the second top panel with the double
return flange by hinging it around the first panel as
illustrated (reference 2)
3. Use the self-tapping sheet metal screws to mount
second panel
2
1
2
SIZE 7-16
SIZE 18-33
2
FOAM TAPE
SIZE 18-33
Rooftop Supply Mixed Flow Fans
®
) on
S
2
Foam Tape
1
SIZE 18-33
7
Advertisement
Table of Contents
