andrews COMBIflo 100/300 Installation, Operation And Maintenance Manual page 43

Parameter Dis-
play
Used as ru = 1
ru = 2
ru = 3
Direct adjust- P1 = 1
ment
P1 = 2
Operation Lock P2 = 0
P2 = 1
A setpoint readjustment with the knob is adopted either by pressing the operating mode button or without any
further confi rmation (timeout).
4.19.7 MANUAL THERMOSTAT (OPTIONAL)
Using the Main GUI on the appliance, enter "Commissioning mode" (see Users operating and programming
guide for details) and select "Confi guration" menu.
Depending on which number of the AGU2.5 expansion module being used (see section 4.17 for details of the
AGU2.5), the setup of the RGB room sensor, for the control of a heating zone is as follows:
Line
6046/6054/6062
6047/6055/6063
ANDREWS COMBIfl o DRAFT
Function
Th e room unit is addressed as RU1 (default setting).
Th e room unit is addressed as RU2.
Th e room unit is addressed as RU3.
Automatic storage: (default)
Save with confi rmation
OFF: All operating elements released (default)
ON: Th e following elements are locked:
- Operation changeover heating circuit.
- Readjustment of comfort setpoint.
- Changeover of operating level (occupancy button)
RGB Room sensor
P/N 5117803
Display
Defi ne function input H2
Defi ne contact type H2
Notes
Setup as "Room thermostat HC1,
HC2 or HC3"
Normally open or normally closed
41 GB/IE