Loading The Racks - Whirlpool WSIO 3O34 PFE X Daily Reference Manual

LOADING THE RACKS

CUTLERY RACK
UPPER RACK
(loading example for the upper rack)
ADJUSTING THE HEIGHT OF THE UPPER RACK
The height of the upper rack can be adjusted: high position to place bulky
crockery in the lower basket and low position to make the most of the tip-
-up supports by creating more space upwards and avoid collision with the
items loaded into lower rack.
The upper rack is equipped with a Upper Rack
height adjuster (see figure), without pressing
the levers, lift it up by simply holding the rack
sides, as soon as the rack is stable in its upper
position. To restore to the lower position, press
the levers A at the sides of the rack and move the
basket downwards.
We strongly recommend that you do not ad-
just the height of the rack when it is loaded.
NEVER raise or lower the basket on one side
only.
The third rack was designed to ho-
use the cutlery. Arrange the cutlery as
shown in the figure.
A separate arrangement of the cutlery
makes collection easier after washing
and improves washing and drying per-
formance.
Knives and other utensils with sharp
edges must be positioned with the
blades facing downwards.
Load delicate and light dishes: glasses,
cups, saucers, low salad bowls.
The upper rack has tip-up supports
which can be used in a vertical position
when arranging tea/ dessert saucers or
in a lower position to load bowls and
food containers.
FOLDABLE FLAPS WITH ADJUSTABLE POSITION
The side foldable flaps can be
fold or unfold to optimize the
arrangement of crockery inside
the rack. Wine glasses can be
placed safely in the foldable flaps
by inserting the stem of each
glass into the corresponding
slots.
Depending on the model:
– to unfold the flaps there is
needed to slide it up and
rotate or release it from the
snaps and pull it down.
– to fold the flaps there is needed to rotate it and slide flaps down or
pull it up and attach flaps to the snaps.
LOWER RACK
(loading example for the lower rack)
®
POWER CLEAN
Power Clean® uses the special water
jets in the rear of cavity to wash more
intensively the high dirty items. The lo-
wer rack has a Power Clean support, a
special pull-out support in the rear of the
rack that can be used to support frying
pans or baking pans in upright position,
thus taking up less space.
Placing the pots/casseroles faced to the Power Clean® component ple-
ase activate the POWER CLEAN® on the panel.
How to use Power Clean®:
1. Adjust the Power Clean® area
G folding down the rear plate
holders to load pots.
2. Load pots and casseroles incli-
ned vertically in Power Clean®
area. Pots have to be inclined
towards the power water jets.
For pots, lids, plates, salad bowls, cutle-
ry etc. Large plates and lids should
ideally be placed at the sides to avoid
interferences with the spray arm.
The lower rack has tip-up supports
which can be used in a vertical position
when arranging plates or in a horizon-
tal position (lower) to load pans and
salad bowls easily.
EN
5