Philips Lumea SC1994 Manual page 17

D Clean & store after treatment
5 Press the flash button to release a flash on your skin. The flash treats the
skin in that spot.
The device makes a soft popping sound. The flash gives you a warm
sensation.
After each flash, it takes up to 3.5 seconds until the device is ready to
flash again. You can release a flash when the 'READY to flash' light lights
up white.
6 Move the device to the next spot, close to, but not overlapping the
previous spot. Make sure that you flash the same area only once.
7 Continue until you have treated the full area. There are two treatment
modes (see 'Two treatment modes: Stamp & Flash and Slide & Flash').
8 Switch off the device when you finished the treatment.
9 Remove hair before every next treatment, as long as hair is still visible.
1 Unplug the device from the power outlet.
2 Let the device cool down.
3 Moisten the soft cloth supplied, with a few drops of water.
4 Take the attachment off the device.
17
English