Table of Contents
Advertisement
How to use
By using the steam cleaning vacuum tool,you can do vacuum cleaning and steam cleaning simultaneously or individually,in an
easy way.
CAUTION
Please check not to put only demineralized water in your tank. We advice you to mix 50%
demineralized water and 50% tap water. In regions more calcareous, you can mix 2/3 demineralized
water to 1/3 tap water.
Handle
Hose
Extension pipe
➊ Assembly and power ON/OFF
Always hold the steam safety switch during steam cleaning.
• Align the extension pipe (2)and the terminal part of the steam
cleaning vacuum tool (3), and connect the two completely until
you hear the "Click". If the steam cleaning vacuum tool and
the extension are not completely connected, the nozzle will be
pulled out or the steam will not be generated.
• Connect the hose (1) and the extension pipe (2) completely
until you hear the "Click" sound.
• When you press the "STEAM" button (4) on the function
control button on the handle part of the hose (1), the steam
will be generated. Initial steam generation time is about 2.5
minutes and it will take a little longer for the cloth to get wet.
You must operate the "STEAM" button after filling the water.
• When you press the "STEAM" button (4)one more time or
press the "OFF" button (5), the steam will stop.
CAUTION
To prevent safety accidents during steam cleaning, if you do not press the steam safety switch
within 30 seconds, the unit will recognize that the cleaning has been completed and turn off the
power. If you want to use the steam again, press the "STEAM" button one more time.
• During initial steam nozzle operation, it will operate for 150 seconds (2.5 minutes) even when you
do not press the steam safety switch.
• About 2 minutes after pressing the "STEAM" button, you can start the cleaning and after about
2.5 minutes, you can check the steam with your eyes.
• The cloth can get wet faster depending on how the steam vacuum tool is used and the time. At
this time, when you replace the cloth, you can clean with a dry cloth.
Basic using method of the steam cleaner
Steam safety switch
How to supply water
How to attach the microfiber cloth
➋ How to supply water, How to attach the microfiber cloth
To supply water, always unplug the power and put the hose handle
on the floor. And then pour the water into the unit.
• Open the water hole cap of the steam cleaning vacuum tool.
• Use the measuring cup to pour 250cc of water and then close the
water hole cap tightly.
When attaching the cloth, you must always turn off the system
power.
• After attaching the cloth on the cloth board, install it on the nozzle
for steam cleaning.
Be careful because the cloth board can be hot.
• After aligning the vacuum tool with the cloth board, press it from
the top. Connect after you hear the clicking sound. The cloth
must be attached on the cloth board for the vacuum tool and the
cloth board to be connected.
13
Advertisement
Table of Contents
