Roland CAMM-1 PRO User Manual page 49

Menu
SP This is normally set to [DISABLE] when performing
COMMAND cutting. When a tool-selection instruction (SP
instruction) is sent from the computer while this is set to
[DISABLE], the SP instruction is ignored and operation
continues without pause. When set to [ENABLE], SP
exchange instructions are accepted and operation
pauses. If tool change is needed, change the tool, then
press the [ENTER] key.
CROP MARK This is used when cutting materials with alignment
marks (crop marks) printed around the graphics, such
as for making stickers or seals. The crop marks are set
as reference points and correction points, enabling the
graphics to be cut with accuracy.
SETTING OVER CUT This cuts an excess margin of 1 mm (0.04 in.) from the DISABLE/ENABLE
MENU first and last line segments.
This selection is normally set to [DISABLE], and is set
to [ENABLE] when cutting especially attractive corners
is desired. When cutting small text or intricate
graphics, however, this should be set to [DISABLE] to
avoid cutting into the material.
AUTO Set to [ENABLE] for automatic material feed at cutting.
PREFEED If this is set to [ENABLE], when cutting data is sent
from the computer, the plotter will automatically execute
cutting after a 1 m (39-3/8 in.) feed toward the front.
(Some data may cause feed over 1 m (39-3/8 in.), such
as when the next point of movement is located more
than 1 m (39-3/8 in.) to the rear.)
* If the [AREA MOVE] function is used to feed the
material in advance, the material will not be
automatically fed even when [AUTO PREFEED] is set
to [ENABLE].
SMOOTHING If you want the curves of circles and arcs to be cut
smoothly, set this to [ENABLE]. When on, however,
small text or intricate designs may also be cut with
rounded corners. If this happens, change the setting to
[DISABLE] and perform cutting again.
CALIB X This adjusts the respective distances of the X axis.
Compare the actual measurements of the cutting
results with the data sent from the computer to
calculate and set the distance adjustment value.
CALIB Y This adjusts the respective distances of the Y axis.
Compare the actual measurements of the cutting
results with the data sent from the computer to
calculate and set the distance adjustment value.
REPLOT This cuts the data in the replot buffer. Selecting
[CLEAR] causes existing data in the replot buffer to be
deleted.
All manuals and user guides at all-guides.com
Function Range Default
DISABLE/ENABLE DISABLE
– –
DISABLE
DISABLE/ENABLE DISABLE
ENABLE/DISABLE ENABLE
-2.00 to 2.00 % 0.00 %
-2.00 to 2.00 % 0.00 %
49