dafi Flow Comfort DC10 Lead Manual page 10

Settings:
SIZE: Type of the filter cartridge
• D1
• D2
• D3
• DC10 Lead
Functions of the multifunctional CHECK/RESET button:
By short-pressing the key (for 1 sec): check the status of the filter cartridge, which is signaled in the
following way:
• blue blinking diode: filter cartridge active,
• yellow blinking diode and 3 series of beeps every 2 hours: you have 7 days to replace the filter car-
tridge,
• red blinking diode and 3 series of beeps every 1 hour: replace the filter cartridge with a new one,
• when the reminder on the need to replace the filter cartridge is on, you can postpone the blinking/
beeping by 12 hours by short-pressing the "CHECK/RESET" button.
Long press (4 sec):
It resets the usage period of the filter cartridge and saves the current settings.
Once the filter size and water hardness have been set, press and hold the CHECK/REST button for 4
seconds to save the settings. If the parameters are not saved after changes, the previous settings will
be restored after 1 minute.
Removal of batteries will not reset the settings.
When the selected type of filter cartridge is DC10 Lead, there is no option for choosing the hardness
(signaled by blinking LED water hardness indicators).
Mounting
If you want to attach the indicator to a non-metal surface (e.g. furniture board, wall, plastic), remove the
film from the stickers on the mounting plate and attach to surface, then connect the indicator to the
mounting plate.
If you want to attach the indicator to a ferromagnetic metal surface (that is attracted by a magnet),
attach it without the back plate; the indicator will be attached thanks to the magnetic properties.
10