Aerpro AMHJP2K Manual page 5

AMHJP2K
Section 1: Disassembly (Cont.)
Part Four: Door Sill Trim Removal
Use a plastic panel removal tool
to remove the panel on the driver
side of the dash.
Remove the two T25 screws on
the underside of the driver side
upper door seal trim.
Step 1
Step 3
Aerpro AERA10 Radio Replacement Kit for Jeep
Wrangler JL and Jeep Gladiator JT Vehicles
Step 2
Use a plastic panel removal tool
to open the driver side handle
bolt covers, then remove the two
10mm bolts.
Step 4
Remove the two T25 screws on
the inner-most side of the driver
side upper door seal trim; then,
while pulling towards the middle
of the vehicle, use a plastic panel
removal tool to remove it.
Page 5