Table of Contents
Advertisement
Auto-adjusting the image
In some cases, you may need to optimize the picture
quality. To do this, press AUTO on the projector or
remote control. Within 3 seconds, the built-in
Intelligent Auto Adjustment function will re-adjust
the values of Frequency, and Clock to provide the
best picture quality.
The current source information will be displayed at
the bottom right of the screen for 3 seconds.
The screen will be blank while AUTO is functioning.
Fine-tuning the image size and clarity
1.
Adjust the projected image to the size
that you need using the zoom ring.
Searching for details on the image
If you need to find the details on the projected image, press D.
ZOOM + on the remote control, the center of the image will be
magnified. When the + button is pressed again, the image is further
magnified. Use the directional arrows ( ,
projector or remote control to navigate the image. Pressing D.
ZOOM - reduces the size of the image. When the - button is pressed
again, the image is further reduced until it is restored to the original
size. You can also restore the original size by pressing RETURN on
the remote control.
Any problems?
If you have other display problems, see
32
Operation
All manuals and user guides at all-guides.com
"Troubleshooting" on page 55
2.
Then sharpen the image by rotating
the focus ring.
,
,
) on the
for details.
Advertisement
Table of Contents
