Table of Contents
Advertisement
Personalisations
C
Setting the temperature
Turn the TEMPERATURE knob to set the wash temperature.
The temperature can be lowered, or even set to a cold wash ( ).
Set the drying cycle
Turn the DRYING knob to set the desired drying type.
Two options are available:
A - Based on time: From 40 minutes to 180.
B - Based on the damp level of the dry clothes:
Iron
: slightly damp clothes, easy to iron.
Hanger
: dry clothes to put away.
Cupboard
: very dry clothes, recommended for towelling and bathrobes.
A cooling stage is foreseen at the end of the drying cycle.
If your laundry load to wash and dry is exceptionally in excess of the maximum load foreseen (see Programme table), perform the
wash cycle, and when the programme is complete, divide up the garments and put part of them back in the drum. Now follow
the instructions provided for a dry only cycle. Repeat this procedure for the remainder of the load.
Dry only
Turn the PROGRAMME knob to one of the drying settings (7-8) depending on the type of fabric, then select the desired drying
type using the DRYING knob.
Important: - A spin cycle is carried out during the drying if you have set a cotton programme and a level of dryness (Cupboard
, Hanger
, Iron
).
- For cotton loads of less than 1 Kg, use the drying programme designed for delicate fabrics.
Functions
To enable a function:
1. press the button corresponding to the desired function, according to the table below;
2. the function is enabled when the corresponding button is illuminated.
Note:
- If the function selected is incompatible with the programme set, the button will flash and the function will not be enabled.
- If you set a function that is incompatible with another function you selected previously, only the last one selected will be
enabled.
Function
Effect
Delays the start of the wash
by up to 9 hours.
Delay Timer
By selecting this function, the
wash and spin cycles will be
modified in order to reduce
the formation of creases.
Easy iron
At the end of the cycle the
washing machine will perform
slow rotations of the drum.
Increases the efficiency of
the rinse.
Extra Rinse
Reduces the spin speed.
1/2
Comments
Press the button repeatedly until the LED corresponding to the desired
delay is turned on.
The fifth time the button is pressed, the function will be disabled.
N.B.: Once you have pressed the Start/Reset button, the delay can only be
decreased if you wish to modify it.
To drain the water so that the laundry may be removed, press the
START / RESET button.
If you also want to run the drying cycle, this button is enabled only if com-
bined with level
(Iron).
Recommended when the appliance has a full load or with large quantities
of detergent.
GB
13
Advertisement
Table of Contents
