Table of Contents
Advertisement
Washer-dryer description
Control panel
GB
Detergent dispenser: to add detergent and fabric
softener.
LEDS: to find out which wash cycle phase is under way.
If the Delay Timer function has been set, the time left until
the programme starts will be indicated.
DRYING knob: to set the desired drying cycle.
FUNCTION buttons: to select the functions available.
The button corresponding to the function selected will
remain on.
TEMPERATURE knob: to set the temperature or the
cold wash cycle.
START/RESET button: to start the programmes or
cancel any incorrect settings.
Note: to avoid excessive vibrations, before every spin cycle the machine distributes the load in a uniform manner by conti-
nuously rotating the drum at a speed which is slightly faster than the normal washing speed.
When, despite repeated attempts, the load is still not evenly distributed, the machine spins at a lower speed than the set
frequency.
If the load is excessively unbalanced, the machine attempts to distribute it instead of spinning.
The balancing attempts may extend the total duration of the cycle, up to a maximum of 10 minutes.
10
Detergent dispenser
FUNCTION
Buttons
Leds
DRYING
Knob
TEMPERATURE
Knob
ON-OFF/DOOR LOCK Led: to find out whether the
Washer-dryer is on and if the appliance door can be
opened.
ON/OFF button: to turn the Washer-dryer on and off.
PROGRAMME knob: to select the wash programmes.
The knob stays still during the cycle.
Standby mode
This washing machine, in compliance with new energy
saving regulations, is fitted with an automatic standby
system which is enabled after about 30 minutes if no acti-
vity is detected. Press the ON-OFF button briefly and wait
for the machine to start up again.
Consumption in off-mode: 0,5 W
Consumption in Left-on: 8 W
ON-OFF/DOOR
LOCK
Led
ON-OFF
Button
START/RESET
Button
Advertisement
Table of Contents
