Table of Contents
Advertisement
5.1
General notes
Here are some general recommendations to follow in order to prevent accidents or damage to the product:
• Unpacking and installation must be performed by at least two people.
• All handling operations must be carried out using appropriate means and in full compliance with
safety regulations.
• The positioning of the packed product must be maintained in accordance with the guidelines supplied by
pictograms and written on the packaging.
• If using ropes, straps, chains, etc., make sure they are suitable for the weight to be unloaded and are in
good condition.
• When moving the package, move with slow and continuous movements to avoid tearing the ropes, chains,
etc.
• Do not tilt excessively in order to avoid overturning.
• Do not stand within range of the loading/unloading means (forklifts, cranes, etc.).
5.2
Unpacking
Unpack the product being careful not to damage or scratch it. Remove the accessory package and any pieces
of polystyrene or cardboard used to block removable parts, etc. from the stove furnace.
Also remember not to leave packaging components (plastic bags, polystyrene, etc.) within the reach of
children, as they could be potential sources of danger. Dispose of them according to regulations.
5.3
Electrical connection
The stove is supplied with a power cable that must be plugged into a 230V 50Hz outlet.
Outlet connection in the rear of the stove is illustrated in Fig. 14.
Absorbed power is indicated in the "SPECIFICATIONS AND TECHNICAL DATA" chapter of this manual.
By law, the system must be properly grounded and with a differential circuit-breaker. Make sure that the
electrical power cable does not come into contact with hot parts when set in its final position.
CAUTION: ensure that the plug for electrical connection remains accessible after stove installation.
5
ASSEMBLY
Fig. 14
17
Advertisement
Table of Contents
