Table of Contents
Advertisement
5.1
General notes
Here are some general recommendations to follow in order to prevent accidents or damage to the
product:
• Unpacking and installation must be performed by at least two people.
• All handling operations must be carried out using appropriate means and in full compliance
with safety regulations.
• The positioning of the packed product must be maintained in accordance with the guidelines supplied
by pictograms and written on the packaging.
• If using ropes, straps, chains, etc., make sure they are suitable for the weight to be unloaded and are
in good condition.
• When moving the package, move with slow and continuous movements to avoid tearing the ropes,
chains, etc.
• Do not tilt excessively in order to avoid overturning.
• Do not stand within range of the loading/unloading means (forklifts, cranes, etc.).
5.2
Unpacking
Unpack the product being careful not to damage or scratch it. Remove the accessory package and any
pieces of polystyrene or cardboard used to block removable parts, etc. from the stove furnace. Also
remember not to leave packaging components (plastic bags, polystyrene, etc.) within the reach of
children, as they could be potential sources of danger. Dispose of them according to regulations.
All local regulations, including those relating to national and European regulations, must be observed when
installing the unit.
Do not use the unit as an incinerator or in any other way other than that for which it was designed. No
other fuel besides wood pellets must be used.
Do not use liquid fuels.
When the stove is turned on, it can reach extremely high temperatures to the touch, especially its outer
surfaces. Operate carefully to avoid burns.
Do not make any unauthorized modifications to the device.
Only use original replacement parts recommended by the manufacturer.
In general
• Make sure that the room where the stove is to be installed offers sufficient ventilation (see section ''1.3
External air intake vent'').
• Make sure that all exhaust system joints are hermetically sealed with silicone (no cementing), are
resistant to heat (250 °C) and are not damaged.
• Periodically check (or have someone check) the cleanliness of exhaust fumes.
• CAUTION: keep all flammable products well away from the stove when it is operating (MINIMUM:
100 cm from the front wall).
• CAUTION: to prevent the escape of fumes, the combustion chamber must be kept closed except
during cleaning operations, to be carried out with the stove off.
• CAUTION: removing the safety guard inside the tank is strictly prohibited.
• CAUTION: in the event of pellet supply while the stove is on, make sure that pellets are not
finished and that the flame remains present in the brazier. Also avoid the fuel sack from coming
into contact with hot surfaces.
• CAUTION: remove any residue of unburned pellets caused by failed ignitions before you start
the stove again.
• CAUTION: if during the ignition phase, the stove does not start and you notice a lot of smoke in
the combustion chamber, immediately turn off the stove and replace the pellets being used, as
5 ASSEMBLY
6
USE
15
Advertisement
Table of Contents
