Menu 04 "Choose Language; Menu 05 "Stand-By Mode; Menu 06 "Buzzer Mode; Menu 07 "Initial Load - LAMINOX IDRO HYDRO Use And Maintenance Instructions

Table of Contents

7.4

Menu 04 "CHOOSE LANGUAGE"

Allows you to select the dialogue language among those available.

7.5

This menu allows you to activate or deactivate "STAND-BY".

Stand-by mode indicates a condition in which the stove shuts off but where it automatically re-ignites as soon

as the room temperature and the water temperature fall below the set value and the flue gas temperature

drops below its threshold (stove is cold). Default setting is "OFF".

Once the stand-by Menu is set to a value between 1'-120', if the water temperature or room temperature

exceed a certain amount, set values (2°C for room temperature and 4° for water temperature), an alternating

message "MODULATE / OK STD BY" appears on the screen. At this point, after a pre-set time (default 10

minutes), if temperatures do not return under the set values, the stove shuts off and goes into stand-by mode.

During shutdown, the display shows the message "WAIT COOLING." This display message remains until re-

lighting conditions are verified.

7.6

When "off," acoustic signal disabled in the event of an alarm. When "on," sets off a buzzer when an alarm is

activated.

7.7

When the display shows the message "OFF," allows you to preload pellets for a time equal to 90 min. Start

by pressing button "1" and stop if desired by pressing button "4." Once preloading is completed, remove the

loaded pellets from the brazier.

7.8

The stove status menu shows the current state of the stove, showing some sensor values and other

variables inside the stove. Four pages displayed in succession are available. This menu is for qualified

service personnel use.

7.9

This menu is protected by an access key and is intended for qualified service personnel.

Table of Contents