4.5.10
Physical device Information
•
Location — which controller and port the drive is located
•
Model— model number of the drive connected
•
Capacity— total capacity of the drive
•
MaxFree— total capacity that is not configured
•
Status— Current state of drive
Rescan
Clicking rescan will force the drivers to report the array status. For any disk(s) you hot plug into the device; do not
click rescan until all physical drives are detected and appear under Logical Device Information.
4.5.11
System Setting
Using this tab, you can change the following:
•
Enable auto-rebuilding
•
Enable rebuilding on error
•
Enable audible alarm
•
Set Spindown Idle Disk(minutes)
Restrict to localhost
•
•
Set rebuild priority
Change port number
•
•
Change temperature unit
•
Change HRM password
29